| Device tree bindings for NOR flash connect to TI GPMC |
| |
| NOR flash connected to the TI GPMC (found on OMAP boards) are represented as |
| child nodes of the GPMC controller with a name of "nor". |
| |
| All timing relevant properties as well as generic GPMC child properties are |
| explained in a separate documents. Please refer to |
| Documentation/devicetree/bindings/bus/ti-gpmc.txt |
| |
| Required properties: |
| - bank-width: Width of NOR flash in bytes. GPMC supports 8-bit and |
| 16-bit devices and so must be either 1 or 2 bytes. |
| - compatible: Documentation/devicetree/bindings/mtd/mtd-physmap.txt |
| - gpmc,cs-on-ns: Chip-select assertion time |
| - gpmc,cs-rd-off-ns: Chip-select de-assertion time for reads |
| - gpmc,cs-wr-off-ns: Chip-select de-assertion time for writes |
| - gpmc,oe-on-ns: Output-enable assertion time |
| - gpmc,oe-off-ns: Output-enable de-assertion time |
| - gpmc,we-on-ns Write-enable assertion time |
| - gpmc,we-off-ns: Write-enable de-assertion time |
| - gpmc,access-ns: Start cycle to first data capture (read access) |
| - gpmc,rd-cycle-ns: Total read cycle time |
| - gpmc,wr-cycle-ns: Total write cycle time |
| - linux,mtd-name: Documentation/devicetree/bindings/mtd/mtd-physmap.txt |
| - reg: Chip-select, base address (relative to chip-select) |
| and size of NOR flash. Note that base address will be |
| typically 0 as this is the start of the chip-select. |
| |
| Optional properties: |
| - gpmc,XXX Additional GPMC timings and settings parameters. See |
| Documentation/devicetree/bindings/bus/ti-gpmc.txt |
| |
| Optional properties for partiton table parsing: |
| - #address-cells: should be set to 1 |
| - #size-cells: should be set to 1 |
| |
| Example: |
| |
| gpmc: gpmc@6e000000 { |
| compatible = "ti,omap3430-gpmc", "simple-bus"; |
| ti,hwmods = "gpmc"; |
| reg = <0x6e000000 0x1000>; |
| interrupts = <20>; |
| gpmc,num-cs = <8>; |
| gpmc,num-waitpins = <4>; |
| #address-cells = <2>; |
| #size-cells = <1>; |
| |
| ranges = <0 0 0x10000000 0x08000000>; |
| |
| nor@0,0 { |
| compatible = "cfi-flash"; |
| linux,mtd-name= "intel,pf48f6000m0y1be"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| reg = <0 0 0x08000000>; |
| bank-width = <2>; |
| |
| gpmc,mux-add-data; |
| gpmc,cs-on-ns = <0>; |
| gpmc,cs-rd-off-ns = <186>; |
| gpmc,cs-wr-off-ns = <186>; |
| gpmc,adv-on-ns = <12>; |
| gpmc,adv-rd-off-ns = <48>; |
| gpmc,adv-wr-off-ns = <48>; |
| gpmc,oe-on-ns = <54>; |
| gpmc,oe-off-ns = <168>; |
| gpmc,we-on-ns = <54>; |
| gpmc,we-off-ns = <168>; |
| gpmc,rd-cycle-ns = <186>; |
| gpmc,wr-cycle-ns = <186>; |
| gpmc,access-ns = <114>; |
| gpmc,page-burst-access-ns = <6>; |
| gpmc,bus-turnaround-ns = <12>; |
| gpmc,cycle2cycle-delay-ns = <18>; |
| gpmc,wr-data-mux-bus-ns = <90>; |
| gpmc,wr-access-ns = <186>; |
| gpmc,cycle2cycle-samecsen; |
| gpmc,cycle2cycle-diffcsen; |
| |
| partition@0 { |
| label = "bootloader-nor"; |
| reg = <0 0x40000>; |
| }; |
| partition@0x40000 { |
| label = "params-nor"; |
| reg = <0x40000 0x40000>; |
| }; |
| partition@0x80000 { |
| label = "kernel-nor"; |
| reg = <0x80000 0x200000>; |
| }; |
| partition@0x280000 { |
| label = "filesystem-nor"; |
| reg = <0x240000 0x7d80000>; |
| }; |
| }; |
| }; |