| # |
| # Makefile for the PCI bus specific drivers. |
| # |
| |
| obj-y += access.o bus.o probe.o remove.o pci.o \ |
| pci-driver.o search.o pci-sysfs.o rom.o setup-res.o \ |
| irq.o vpd.o |
| obj-$(CONFIG_PROC_FS) += proc.o |
| obj-$(CONFIG_SYSFS) += slot.o |
| |
| obj-$(CONFIG_PCI_QUIRKS) += quirks.o |
| |
| # Build PCI Express stuff if needed |
| obj-$(CONFIG_PCIEPORTBUS) += pcie/ |
| |
| obj-$(CONFIG_PCI_IOAPIC) += ioapic.o |
| |
| obj-$(CONFIG_HOTPLUG) += hotplug.o |
| |
| # Build the PCI Hotplug drivers if we were asked to |
| obj-$(CONFIG_HOTPLUG_PCI) += hotplug/ |
| ifdef CONFIG_HOTPLUG_PCI |
| obj-y += hotplug-pci.o |
| endif |
| |
| # Build the PCI MSI interrupt support |
| obj-$(CONFIG_PCI_MSI) += msi.o |
| |
| # Build the Hypertransport interrupt support |
| obj-$(CONFIG_HT_IRQ) += htirq.o |
| |
| # Build Intel IOMMU support |
| obj-$(CONFIG_DMAR) += dmar.o iova.o intel-iommu.o |
| |
| obj-$(CONFIG_INTR_REMAP) += dmar.o intr_remapping.o |
| |
| obj-$(CONFIG_PCI_IOV) += iov.o |
| |
| # |
| # Some architectures use the generic PCI setup functions |
| # |
| obj-$(CONFIG_X86) += setup-bus.o |
| obj-$(CONFIG_ALPHA) += setup-bus.o setup-irq.o |
| obj-$(CONFIG_ARM) += setup-bus.o setup-irq.o |
| obj-$(CONFIG_PARISC) += setup-bus.o |
| obj-$(CONFIG_SUPERH) += setup-bus.o setup-irq.o |
| obj-$(CONFIG_PPC) += setup-bus.o |
| obj-$(CONFIG_MIPS) += setup-bus.o setup-irq.o |
| obj-$(CONFIG_X86_VISWS) += setup-irq.o |
| obj-$(CONFIG_MN10300) += setup-bus.o |
| obj-$(CONFIG_MICROBLAZE) += setup-bus.o |
| obj-$(CONFIG_TILE) += setup-bus.o setup-irq.o |
| |
| # |
| # ACPI Related PCI FW Functions |
| # |
| obj-$(CONFIG_ACPI) += pci-acpi.o |
| |
| # SMBIOS provided firmware instance and labels |
| obj-$(CONFIG_DMI) += pci-label.o |
| |
| # Cardbus & CompactPCI use setup-bus |
| obj-$(CONFIG_HOTPLUG) += setup-bus.o |
| |
| obj-$(CONFIG_PCI_SYSCALL) += syscall.o |
| |
| obj-$(CONFIG_PCI_STUB) += pci-stub.o |
| |
| obj-$(CONFIG_XEN_PCIDEV_FRONTEND) += xen-pcifront.o |
| |
| ccflags-$(CONFIG_PCI_DEBUG) := -DDEBUG |