| /* |
| * Copyright (C) 2005 - 2008 ServerEngines |
| * All rights reserved. |
| * |
| * This program is free software; you can redistribute it and/or |
| * modify it under the terms of the GNU General Public License version 2 |
| * as published by the Free Software Foundation. The full GNU General |
| * Public License is included in this distribution in the file called COPYING. |
| * |
| * Contact Information: |
| * linux-drivers@serverengines.com |
| * |
| * ServerEngines |
| * 209 N. Fair Oaks Ave |
| * Sunnyvale, CA 94085 |
| */ |
| /* |
| * Autogenerated by srcgen version: 0127 |
| */ |
| #ifndef __fwcmd_common_amap_h__ |
| #define __fwcmd_common_amap_h__ |
| #include "host_struct.h" |
| |
| /* --- PHY_LINK_DUPLEX_ENUM --- */ |
| #define PHY_LINK_DUPLEX_NONE (0) |
| #define PHY_LINK_DUPLEX_HALF (1) |
| #define PHY_LINK_DUPLEX_FULL (2) |
| |
| /* --- PHY_LINK_SPEED_ENUM --- */ |
| #define PHY_LINK_SPEED_ZERO (0) /* No link. */ |
| #define PHY_LINK_SPEED_10MBPS (1) /* 10 Mbps */ |
| #define PHY_LINK_SPEED_100MBPS (2) /* 100 Mbps */ |
| #define PHY_LINK_SPEED_1GBPS (3) /* 1 Gbps */ |
| #define PHY_LINK_SPEED_10GBPS (4) /* 10 Gbps */ |
| |
| /* --- PHY_LINK_FAULT_ENUM --- */ |
| #define PHY_LINK_FAULT_NONE (0) /* No fault status |
| available or detected */ |
| #define PHY_LINK_FAULT_LOCAL (1) /* Local fault detected */ |
| #define PHY_LINK_FAULT_REMOTE (2) /* Remote fault detected */ |
| |
| /* --- BE_ULP_MASK --- */ |
| #define BE_ULP0_MASK (1) |
| #define BE_ULP1_MASK (2) |
| #define BE_ULP2_MASK (4) |
| |
| /* --- NTWK_ACTIVE_PORT --- */ |
| #define NTWK_PORT_A (0) /* Port A is currently active */ |
| #define NTWK_PORT_B (1) /* Port B is currently active */ |
| #define NTWK_NO_ACTIVE_PORT (15) /* Both ports have lost link */ |
| |
| /* --- NTWK_LINK_TYPE --- */ |
| #define NTWK_LINK_TYPE_PHYSICAL (0) /* link up/down event |
| applies to BladeEngine's |
| Physical Ports |
| */ |
| #define NTWK_LINK_TYPE_VIRTUAL (1) /* Virtual link up/down event |
| reported by BladeExchange. |
| This applies only when the |
| VLD feature is enabled |
| */ |
| |
| /* |
| * --- FWCMD_MAC_TYPE_ENUM --- |
| * This enum defines the types of MAC addresses in the RXF MAC Address Table. |
| */ |
| #define MAC_ADDRESS_TYPE_STORAGE (0) /* Storage MAC Address */ |
| #define MAC_ADDRESS_TYPE_NETWORK (1) /* Network MAC Address */ |
| #define MAC_ADDRESS_TYPE_PD (2) /* Protection Domain MAC Addr */ |
| #define MAC_ADDRESS_TYPE_MANAGEMENT (3) /* Managment MAC Address */ |
| |
| |
| /* --- FWCMD_RING_TYPE_ENUM --- */ |
| #define FWCMD_RING_TYPE_ETH_RX (1) /* Ring created with */ |
| /* FWCMD_COMMON_ETH_RX_CREATE. */ |
| #define FWCMD_RING_TYPE_ETH_TX (2) /* Ring created with */ |
| /* FWCMD_COMMON_ETH_TX_CREATE. */ |
| #define FWCMD_RING_TYPE_ISCSI_WRBQ (3) /* Ring created with */ |
| /* FWCMD_COMMON_ISCSI_WRBQ_CREATE. */ |
| #define FWCMD_RING_TYPE_ISCSI_DEFQ (4) /* Ring created with */ |
| /* FWCMD_COMMON_ISCSI_DEFQ_CREATE. */ |
| #define FWCMD_RING_TYPE_TPM_WRBQ (5) /* Ring created with */ |
| /* FWCMD_COMMON_TPM_WRBQ_CREATE. */ |
| #define FWCMD_RING_TYPE_TPM_DEFQ (6) /* Ring created with */ |
| /* FWCMD_COMMONTPM_TDEFQ_CREATE. */ |
| #define FWCMD_RING_TYPE_TPM_RQ (7) /* Ring created with */ |
| /* FWCMD_COMMON_TPM_RQ_CREATE. */ |
| #define FWCMD_RING_TYPE_MCC (8) /* Ring created with */ |
| /* FWCMD_COMMON_MCC_CREATE. */ |
| #define FWCMD_RING_TYPE_CQ (9) /* Ring created with */ |
| /* FWCMD_COMMON_CQ_CREATE. */ |
| #define FWCMD_RING_TYPE_EQ (10) /* Ring created with */ |
| /* FWCMD_COMMON_EQ_CREATE. */ |
| #define FWCMD_RING_TYPE_QP (11) /* Ring created with */ |
| /* FWCMD_RDMA_QP_CREATE. */ |
| |
| |
| /* --- ETH_TX_RING_TYPE_ENUM --- */ |
| #define ETH_TX_RING_TYPE_FORWARDING (1) /* Ethernet ring for |
| forwarding packets */ |
| #define ETH_TX_RING_TYPE_STANDARD (2) /* Ethernet ring for sending |
| network packets. */ |
| #define ETH_TX_RING_TYPE_BOUND (3) /* Ethernet ring bound to the |
| port specified in the command |
| header.port_number field. |
| Rings of this type are |
| NOT subject to the |
| failover logic implemented |
| in the BladeEngine. |
| */ |
| |
| /* --- FWCMD_COMMON_QOS_TYPE_ENUM --- */ |
| #define QOS_BITS_NIC (1) /* max_bits_per_second_NIC */ |
| /* field is valid. */ |
| #define QOS_PKTS_NIC (2) /* max_packets_per_second_NIC */ |
| /* field is valid. */ |
| #define QOS_IOPS_ISCSI (4) /* max_ios_per_second_iSCSI */ |
| /*field is valid. */ |
| #define QOS_VLAN_TAG (8) /* domain_VLAN_tag field |
| is valid. */ |
| #define QOS_FABRIC_ID (16) /* fabric_domain_ID field |
| is valid. */ |
| #define QOS_OEM_PARAMS (32) /* qos_params_oem field |
| is valid. */ |
| #define QOS_TPUT_ISCSI (64) /* max_bytes_per_second_iSCSI |
| field is valid. */ |
| |
| |
| /* |
| * --- FAILOVER_CONFIG_ENUM --- |
| * Failover configuration setting used in FWCMD_COMMON_FORCE_FAILOVER |
| */ |
| #define FAILOVER_CONFIG_NO_CHANGE (0) /* No change to automatic */ |
| /* port failover setting. */ |
| #define FAILOVER_CONFIG_ON (1) /* Automatic port failover |
| on link down is enabled. */ |
| #define FAILOVER_CONFIG_OFF (2) /* Automatic port failover |
| on link down is disabled. */ |
| |
| /* |
| * --- FAILOVER_PORT_ENUM --- |
| * Failover port setting used in FWCMD_COMMON_FORCE_FAILOVER |
| */ |
| #define FAILOVER_PORT_A (0) /* Selects port A. */ |
| #define FAILOVER_PORT_B (1) /* Selects port B. */ |
| #define FAILOVER_PORT_NONE (15) /* No port change requested. */ |
| |
| |
| /* |
| * --- MGMT_FLASHROM_OPCODE --- |
| * Flash ROM operation code |
| */ |
| #define MGMT_FLASHROM_OPCODE_FLASH (1) /* Commit downloaded data |
| to Flash ROM */ |
| #define MGMT_FLASHROM_OPCODE_SAVE (2) /* Save downloaded data to |
| ARM's DDR - do not flash */ |
| #define MGMT_FLASHROM_OPCODE_CLEAR (3) /* Erase specified component |
| from FlashROM */ |
| #define MGMT_FLASHROM_OPCODE_REPORT (4) /* Read specified component |
| from Flash ROM */ |
| #define MGMT_FLASHROM_OPCODE_IMAGE_INFO (5) /* Returns size of a |
| component */ |
| |
| /* |
| * --- MGMT_FLASHROM_OPTYPE --- |
| * Flash ROM operation type |
| */ |
| #define MGMT_FLASHROM_OPTYPE_CODE_FIRMWARE (0) /* Includes ARM firmware, |
| IPSec (optional) and EP |
| firmware */ |
| #define MGMT_FLASHROM_OPTYPE_CODE_REDBOOT (1) |
| #define MGMT_FLASHROM_OPTYPE_CODE_BIOS (2) |
| #define MGMT_FLASHROM_OPTYPE_CODE_PXE_BIOS (3) |
| #define MGMT_FLASHROM_OPTYPE_CODE_CTRLS (4) |
| #define MGMT_FLASHROM_OPTYPE_CFG_IPSEC (5) |
| #define MGMT_FLASHROM_OPTYPE_CFG_INI (6) |
| #define MGMT_FLASHROM_OPTYPE_ROM_OFFSET_SPECIFIED (7) |
| |
| /* |
| * --- FLASHROM_TYPE --- |
| * Flash ROM manufacturers supported in the f/w |
| */ |
| #define INTEL (0) |
| #define SPANSION (1) |
| #define MICRON (2) |
| |
| /* --- DDR_CAS_TYPE --- */ |
| #define CAS_3 (0) |
| #define CAS_4 (1) |
| #define CAS_5 (2) |
| |
| /* --- DDR_SIZE_TYPE --- */ |
| #define SIZE_256MB (0) |
| #define SIZE_512MB (1) |
| |
| /* --- DDR_MODE_TYPE --- */ |
| #define DDR_NO_ECC (0) |
| #define DDR_ECC (1) |
| |
| /* --- INTERFACE_10GB_TYPE --- */ |
| #define CX4_TYPE (0) |
| #define XFP_TYPE (1) |
| |
| /* --- BE_CHIP_MAX_MTU --- */ |
| #define CHIP_MAX_MTU (9000) |
| |
| /* --- XAUI_STATE_ENUM --- */ |
| #define XAUI_STATE_ENABLE (0) /* This MUST be the default |
| value for all requests |
| which set/change |
| equalization parameter. */ |
| #define XAUI_STATE_DISABLE (255) /* The XAUI for both ports |
| may be disabled for EMI |
| tests. There is no |
| provision for turning off |
| individual ports. |
| */ |
| /* --- BE_ASIC_REVISION --- */ |
| #define BE_ASIC_REV_A0 (1) |
| #define BE_ASIC_REV_A1 (2) |
| |
| #endif /* __fwcmd_common_amap_h__ */ |
