| config PPC_MPC52xx |
| bool "52xx-based boards" |
| depends on PPC_MULTIPLATFORM && PPC32 |
| select FSL_SOC |
| select PPC_CLOCK |
| |
| config PPC_MPC5200_SIMPLE |
| bool "Generic support for simple MPC5200 based boards" |
| depends on PPC_MPC52xx |
| select DEFAULT_UIMAGE |
| help |
| This option enables support for a simple MPC52xx based boards which |
| do not need a custom platform specific setup. Such boards are |
| supported assuming the following: |
| |
| - GPIO pins are configured by the firmware, |
| - CDM configuration (clocking) is setup correctly by firmware, |
| - if the 'fsl,has-wdt' property is present in one of the |
| gpt nodes, then it is safe to use such gpt to reset the board, |
| - PCI is supported if enabled in the kernel configuration |
| and if there is a PCI bus node defined in the device tree. |
| |
| Boards that are compatible with this generic platform support |
| are: 'tqc,tqm5200', 'promess,motionpro', 'schindler,cm5200'. |
| |
| config PPC_EFIKA |
| bool "bPlan Efika 5k2. MPC5200B based computer" |
| depends on PPC_MPC52xx |
| select PPC_RTAS |
| select RTAS_PROC |
| select PPC_NATIVE |
| |
| config PPC_LITE5200 |
| bool "Freescale Lite5200 Eval Board" |
| depends on PPC_MPC52xx |
| select DEFAULT_UIMAGE |
| |
| config PPC_MPC5200_BUGFIX |
| bool "MPC5200 (L25R) bugfix support" |
| depends on PPC_MPC52xx |
| help |
| Enable workarounds for original MPC5200 errata. This is not required |
| for MPC5200B based boards. |
| |
| It is safe to say 'Y' here |
| |
| config PPC_MPC5200_GPIO |
| bool "MPC5200 GPIO support" |
| depends on PPC_MPC52xx |
| select HAVE_GPIO_LIB |
| help |
| Enable gpiolib support for mpc5200 based boards |
