| if ARCH_LPC32XX |
| |
| menu "Individual UART enable selections" |
| |
| config ARCH_LPC32XX_UART3_SELECT |
| bool "Add support for standard UART3" |
| help |
| Adds support for standard UART 3 when the 8250 serial support |
| is enabled. |
| |
| config ARCH_LPC32XX_UART4_SELECT |
| bool "Add support for standard UART4" |
| help |
| Adds support for standard UART 4 when the 8250 serial support |
| is enabled. |
| |
| config ARCH_LPC32XX_UART5_SELECT |
| bool "Add support for standard UART5" |
| default y |
| help |
| Adds support for standard UART 5 when the 8250 serial support |
| is enabled. |
| |
| config ARCH_LPC32XX_UART6_SELECT |
| bool "Add support for standard UART6" |
| help |
| Adds support for standard UART 6 when the 8250 serial support |
| is enabled. |
| |
| endmenu |
| |
| menu "LPC32XX chip components" |
| |
| config ARCH_LPC32XX_IRAM_FOR_NET |
| bool "Use IRAM for network buffers" |
| default y |
| help |
| Say Y here to use the LPC internal fast IRAM (i.e. 256KB SRAM) as |
| network buffer. If the total combined required buffer sizes is |
| larger than the size of IRAM, then SDRAM will be used instead. |
| |
| This can be enabled safely if the IRAM is not intended for other |
| uses. |
| |
| config ARCH_LPC32XX_MII_SUPPORT |
| bool "Check to enable MII support or leave disabled for RMII support" |
| help |
| Say Y here to enable MII support, or N for RMII support. Regardless of |
| which support is selected, the ethernet interface driver needs to be |
| selected in the device driver networking section. |
| |
| The PHY3250 reference board uses RMII, so users of this board should |
| say N. |
| |
| endmenu |
| |
| endif |
| |
