blob: b43fdb4f731973544e1a55f700c779e4191d76bb [file] [log] [blame]
/*
* Copyright (c) 2005-2011 Atheros Communications Inc.
* Copyright (c) 2011-2013 Qualcomm Atheros, Inc.
*
* Permission to use, copy, modify, and/or distribute this software for any
* purpose with or without fee is hereby granted, provided that the above
* copyright notice and this permission notice appear in all copies.
*
* THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
* WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
* ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
* WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
* ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
* OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
*/
#ifndef _PCI_H_
#define _PCI_H_
#include <linux/interrupt.h>
#include "hw.h"
#include "ce.h"
/* FW dump area */
#define REG_DUMP_COUNT_QCA988X 60
/*
* maximum number of bytes that can be handled atomically by DiagRead/DiagWrite
*/
#define DIAG_TRANSFER_LIMIT 2048
/*
* maximum number of bytes that can be
* handled atomically by DiagRead/DiagWrite
*/
#define DIAG_TRANSFER_LIMIT 2048
struct bmi_xfer {
struct completion done;
bool wait_for_resp;
u32 resp_len;
};
/*
* PCI-specific Target state
*
* NOTE: Structure is shared between Host software and Target firmware!
*
* Much of this may be of interest to the Host so
* HOST_INTEREST->hi_interconnect_state points here
* (and all members are 32-bit quantities in order to
* facilitate Host access). In particular, Host software is
* required to initialize pipe_cfg_addr and svc_to_pipe_map.
*/
struct pcie_state {
/* Pipe configuration Target address */
/* NB: ce_pipe_config[CE_COUNT] */
u32 pipe_cfg_addr;
/* Service to pipe map Target address */
/* NB: service_to_pipe[PIPE_TO_CE_MAP_CN] */
u32 svc_to_pipe_map;
/* number of MSI interrupts requested */
u32 msi_requested;
/* number of MSI interrupts granted */
u32 msi_granted;
/* Message Signalled Interrupt address */
u32 msi_addr;
/* Base data */
u32 msi_data;
/*
* Data for firmware interrupt;
* MSI data for other interrupts are
* in various SoC registers
*/
u32 msi_fw_intr_data;
/* PCIE_PWR_METHOD_* */
u32 power_mgmt_method;
/* PCIE_CONFIG_FLAG_* */
u32 config_flags;
};
/* PCIE_CONFIG_FLAG definitions */
#define PCIE_CONFIG_FLAG_ENABLE_L1 0x0000001
/* Host software's Copy Engine configuration. */
#define CE_ATTR_FLAGS 0
/*
* Configuration information for a Copy Engine pipe.
* Passed from Host to Target during startup (one per CE).
*
* NOTE: Structure is shared between Host software and Target firmware!
*/
struct ce_pipe_config {
u32 pipenum;
u32 pipedir;
u32 nentries;
u32 nbytes_max;
u32 flags;
u32 reserved;
};
/*
* Directions for interconnect pipe configuration.
* These definitions may be used during configuration and are shared
* between Host and Target.
*
* Pipe Directions are relative to the Host, so PIPEDIR_IN means
* "coming IN over air through Target to Host" as with a WiFi Rx operation.
* Conversely, PIPEDIR_OUT means "going OUT from Host through Target over air"
* as with a WiFi Tx operation. This is somewhat awkward for the "middle-man"
* Target since things that are "PIPEDIR_OUT" are coming IN to the Target
* over the interconnect.
*/
#define PIPEDIR_NONE 0
#define PIPEDIR_IN 1 /* Target-->Host, WiFi Rx direction */
#define PIPEDIR_OUT 2 /* Host->Target, WiFi Tx direction */
#define PIPEDIR_INOUT 3 /* bidirectional */
/* Establish a mapping between a service/direction and a pipe. */
struct service_to_pipe {
u32 service_id;
u32 pipedir;
u32 pipenum;
};
enum ath10k_pci_features {
ATH10K_PCI_FEATURE_MSI_X = 0,
ATH10K_PCI_FEATURE_SOC_POWER_SAVE = 1,
/* keep last */
ATH10K_PCI_FEATURE_COUNT
};
/* Per-pipe state. */
struct ath10k_pci_pipe {
/* Handle of underlying Copy Engine */
struct ath10k_ce_pipe *ce_hdl;
/* Our pipe number; facilitiates use of pipe_info ptrs. */
u8 pipe_num;
/* Convenience back pointer to hif_ce_state. */
struct ath10k *hif_ce_state;
size_t buf_sz;
/* protects compl_free and num_send_allowed */
spinlock_t pipe_lock;
struct ath10k_pci *ar_pci;
struct tasklet_struct intr;
};
struct ath10k_pci {
struct pci_dev *pdev;
struct device *dev;
struct ath10k *ar;
void __iomem *mem;
DECLARE_BITMAP(features, ATH10K_PCI_FEATURE_COUNT);
/*
* Number of MSI interrupts granted, 0 --> using legacy PCI line
* interrupts.
*/
int num_msi_intrs;
struct tasklet_struct intr_tq;
struct tasklet_struct msi_fw_err;
struct tasklet_struct early_irq_tasklet;
int started;
atomic_t keep_awake_count;
bool verified_awake;
struct ath10k_pci_pipe pipe_info[CE_COUNT_MAX];
struct ath10k_hif_cb msg_callbacks_current;
/* Target address used to signal a pending firmware event */
u32 fw_indicator_address;
/* Copy Engine used for Diagnostic Accesses */
struct ath10k_ce_pipe *ce_diag;
/* FIXME: document what this really protects */
spinlock_t ce_lock;
/* Map CE id to ce_state */
struct ath10k_ce_pipe ce_states[CE_COUNT_MAX];
};
static inline struct ath10k_pci *ath10k_pci_priv(struct ath10k *ar)
{
return ar->hif.priv;
}
static inline u32 ath10k_pci_reg_read32(struct ath10k *ar, u32 addr)
{
struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
return ioread32(ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS + addr);
}
static inline void ath10k_pci_reg_write32(struct ath10k *ar, u32 addr, u32 val)
{
struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
iowrite32(val, ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS + addr);
}
#define ATH_PCI_RESET_WAIT_MAX 10 /* ms */
#define PCIE_WAKE_TIMEOUT 5000 /* 5ms */
#define BAR_NUM 0
#define CDC_WAR_MAGIC_STR 0xceef0000
#define CDC_WAR_DATA_CE 4
/*
* TODO: Should be a function call specific to each Target-type.
* This convoluted macro converts from Target CPU Virtual Address Space to CE
* Address Space. As part of this process, we conservatively fetch the current
* PCIE_BAR. MOST of the time, this should match the upper bits of PCI space
* for this device; but that's not guaranteed.
*/
#define TARG_CPU_SPACE_TO_CE_SPACE(ar, pci_addr, addr) \
(((ioread32((pci_addr)+(SOC_CORE_BASE_ADDRESS| \
CORE_CTRL_ADDRESS)) & 0x7ff) << 21) | \
0x100000 | ((addr) & 0xfffff))
/* Wait up to this many Ms for a Diagnostic Access CE operation to complete */
#define DIAG_ACCESS_CE_TIMEOUT_MS 10
/*
* This API allows the Host to access Target registers directly
* and relatively efficiently over PCIe.
* This allows the Host to avoid extra overhead associated with
* sending a message to firmware and waiting for a response message
* from firmware, as is done on other interconnects.
*
* Yet there is some complexity with direct accesses because the
* Target's power state is not known a priori. The Host must issue
* special PCIe reads/writes in order to explicitly wake the Target
* and to verify that it is awake and will remain awake.
*
* Usage:
*
* Use ath10k_pci_read32 and ath10k_pci_write32 to access Target space.
* These calls must be bracketed by ath10k_pci_wake and
* ath10k_pci_sleep. A single BEGIN/END pair is adequate for
* multiple READ/WRITE operations.
*
* Use ath10k_pci_wake to put the Target in a state in
* which it is legal for the Host to directly access it. This
* may involve waking the Target from a low power state, which
* may take up to 2Ms!
*
* Use ath10k_pci_sleep to tell the Target that as far as
* this code path is concerned, it no longer needs to remain
* directly accessible. BEGIN/END is under a reference counter;
* multiple code paths may issue BEGIN/END on a single targid.
*/
static inline void ath10k_pci_write32(struct ath10k *ar, u32 offset,
u32 value)
{
struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
iowrite32(value, ar_pci->mem + offset);
}
static inline u32 ath10k_pci_read32(struct ath10k *ar, u32 offset)
{
struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
return ioread32(ar_pci->mem + offset);
}
static inline u32 ath10k_pci_soc_read32(struct ath10k *ar, u32 addr)
{
return ath10k_pci_read32(ar, RTC_SOC_BASE_ADDRESS + addr);
}
static inline void ath10k_pci_soc_write32(struct ath10k *ar, u32 addr, u32 val)
{
ath10k_pci_write32(ar, RTC_SOC_BASE_ADDRESS + addr, val);
}
int ath10k_do_pci_wake(struct ath10k *ar);
void ath10k_do_pci_sleep(struct ath10k *ar);
static inline int ath10k_pci_wake(struct ath10k *ar)
{
struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
if (test_bit(ATH10K_PCI_FEATURE_SOC_POWER_SAVE, ar_pci->features))
return ath10k_do_pci_wake(ar);
return 0;
}
static inline void ath10k_pci_sleep(struct ath10k *ar)
{
struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
if (test_bit(ATH10K_PCI_FEATURE_SOC_POWER_SAVE, ar_pci->features))
ath10k_do_pci_sleep(ar);
}
#endif /* _PCI_H_ */