blob: 7e49c43b7af3501f953cac4796e4769da542c29d [file] [log] [blame]
#
# Atmel device configuration
#
config NET_CADENCE
bool "Cadence devices"
depends on HAS_IOMEM && (ARM || AVR32 || COMPILE_TEST)
default y
---help---
If you have a network (Ethernet) card belonging to this class, say Y.
Make sure you know the name of your card. Read the Ethernet-HOWTO,
available from <http://www.tldp.org/docs.html#howto>.
If unsure, say Y.
Note that the answer to this question doesn't directly affect the
kernel: saying N will just cause the configurator to skip all
the remaining Atmel network card questions. If you say Y, you will be
asked for your specific card in the following questions.
if NET_CADENCE
config ARM_AT91_ETHER
tristate "AT91RM9200 Ethernet support"
depends on HAS_DMA && (ARCH_AT91RM9200 || COMPILE_TEST)
select MACB
---help---
If you wish to compile a kernel for the AT91RM9200 and enable
ethernet support, then you should always answer Y to this.
config MACB
tristate "Cadence MACB/GEM support"
depends on HAS_DMA && (PLATFORM_AT32AP || ARCH_AT91 || ARCH_PICOXCELL || ARCH_ZYNQ || COMPILE_TEST)
select PHYLIB
---help---
The Cadence MACB ethernet interface is found on many Atmel AT32 and
AT91 parts. This driver also supports the Cadence GEM (Gigabit
Ethernet MAC found in some ARM SoC devices). Note: the Gigabit mode
is not yet supported. Say Y to include support for the MACB/GEM chip.
To compile this driver as a module, choose M here: the module
will be called macb.
endif # NET_CADENCE