blob: e7f8d7ed47ebfabb67de32b9b611ed52aca4bf35 [file] [log] [blame]
Device tree bindings for GPMC connected NANDs
GPMC connected NAND (found on OMAP boards) are represented as child nodes of
the GPMC controller with a name of "nand".
All timing relevant properties as well as generic gpmc child properties are
explained in a separate documents - please refer to
Documentation/devicetree/bindings/bus/ti-gpmc.txt
For NAND specific properties such as ECC modes or bus width, please refer to
Documentation/devicetree/bindings/mtd/nand.txt
Required properties:
- reg: The CS line the peripheral is connected to
Optional properties:
- nand-bus-width: Set this numeric value to 16 if the hardware
is wired that way. If not specified, a bus
width of 8 is assumed.
- ti,nand-ecc-opt: A string setting the ECC layout to use. One of:
"sw" Software method (default)
"hw" Hardware method
"hw-romcode" gpmc hamming mode method & romcode layout
"bch4" 4-bit BCH ecc code
"bch8" 8-bit BCH ecc code
- elm_id: Specifies elm device node. This is required to support BCH
error correction using ELM module.
For inline partiton table parsing (optional):
- #address-cells: should be set to 1
- #size-cells: should be set to 1
Example for an AM33xx board:
gpmc: gpmc@50000000 {
compatible = "ti,am3352-gpmc";
ti,hwmods = "gpmc";
reg = <0x50000000 0x1000000>;
interrupts = <100>;
gpmc,num-cs = <8>;
gpmc,num-waitpins = <2>;
#address-cells = <2>;
#size-cells = <1>;
ranges = <0 0 0x08000000 0x2000>; /* CS0: NAND */
elm_id = <&elm>;
nand@0,0 {
reg = <0 0 0>; /* CS0, offset 0 */
nand-bus-width = <16>;
ti,nand-ecc-opt = "bch8";
gpmc,sync-clk = <0>;
gpmc,cs-on = <0>;
gpmc,cs-rd-off = <44>;
gpmc,cs-wr-off = <44>;
gpmc,adv-on = <6>;
gpmc,adv-rd-off = <34>;
gpmc,adv-wr-off = <44>;
gpmc,we-off = <40>;
gpmc,oe-off = <54>;
gpmc,access = <64>;
gpmc,rd-cycle = <82>;
gpmc,wr-cycle = <82>;
gpmc,wr-access = <40>;
gpmc,wr-data-mux-bus = <0>;
#address-cells = <1>;
#size-cells = <1>;
/* partitions go here */
};
};