| /* orinoco_pci.c |
| * |
| * Driver for Prism 2.5/3 devices that have a direct PCI interface |
| * (i.e. these are not PCMCIA cards in a PCMCIA-to-PCI bridge). |
| * The card contains only one PCI region, which contains all the usual |
| * hermes registers, as well as the COR register. |
| * |
| * Current maintainers are: |
| * Pavel Roskin <proski AT gnu.org> |
| * and David Gibson <hermes AT gibson.dropbear.id.au> |
| * |
| * Some of this code is borrowed from orinoco_plx.c |
| * Copyright (C) 2001 Daniel Barlow <dan AT telent.net> |
| * Some of this code is "inspired" by linux-wlan-ng-0.1.10, but nothing |
| * has been copied from it. linux-wlan-ng-0.1.10 is originally : |
| * Copyright (C) 1999 AbsoluteValue Systems, Inc. All Rights Reserved. |
| * This file originally written by: |
| * Copyright (C) 2001 Jean Tourrilhes <jt AT hpl.hp.com> |
| * And is now maintained by: |
| * (C) Copyright David Gibson, IBM Corp. 2002-2003. |
| * |
| * The contents of this file are subject to the Mozilla Public License |
| * Version 1.1 (the "License"); you may not use this file except in |
| * compliance with the License. You may obtain a copy of the License |
| * at http://www.mozilla.org/MPL/ |
| * |
| * Software distributed under the License is distributed on an "AS IS" |
| * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See |
| * the License for the specific language governing rights and |
| * limitations under the License. |
| * |
| * Alternatively, the contents of this file may be used under the |
| * terms of the GNU General Public License version 2 (the "GPL"), in |
| * which case the provisions of the GPL are applicable instead of the |
| * above. If you wish to allow the use of your version of this file |
| * only under the terms of the GPL and not to allow others to use your |
| * version of this file under the MPL, indicate your decision by |
| * deleting the provisions above and replace them with the notice and |
| * other provisions required by the GPL. If you do not delete the |
| * provisions above, a recipient may use your version of this file |
| * under either the MPL or the GPL. |
| */ |
| |
| #define DRIVER_NAME "orinoco_pci" |
| #define PFX DRIVER_NAME ": " |
| |
| #include <linux/module.h> |
| #include <linux/kernel.h> |
| #include <linux/init.h> |
| #include <linux/delay.h> |
| #include <linux/pci.h> |
| |
| #include "orinoco.h" |
| #include "orinoco_pci.h" |
| |
| /* Offset of the COR register of the PCI card */ |
| #define HERMES_PCI_COR (0x26) |
| |
| /* Bitmask to reset the card */ |
| #define HERMES_PCI_COR_MASK (0x0080) |
| |
| /* Magic timeouts for doing the reset. |
| * Those times are straight from wlan-ng, and it is claimed that they |
| * are necessary. Alan will kill me. Take your time and grab a coffee. */ |
| #define HERMES_PCI_COR_ONT (250) /* ms */ |
| #define HERMES_PCI_COR_OFFT (500) /* ms */ |
| #define HERMES_PCI_COR_BUSYT (500) /* ms */ |
| |
| /* |
| * Do a soft reset of the card using the Configuration Option Register |
| * We need this to get going... |
| * This is the part of the code that is strongly inspired from wlan-ng |
| * |
| * Note : This code is done with irq enabled. This mean that many |
| * interrupts will occur while we are there. This is why we use the |
| * jiffies to regulate time instead of a straight mdelay(). Usually we |
| * need only around 245 iteration of the loop to do 250 ms delay. |
| * |
| * Note bis : Don't try to access HERMES_CMD during the reset phase. |
| * It just won't work ! |
| */ |
| static int orinoco_pci_cor_reset(struct orinoco_private *priv) |
| { |
| hermes_t *hw = &priv->hw; |
| unsigned long timeout; |
| u16 reg; |
| |
| /* Assert the reset until the card notices */ |
| hermes_write_regn(hw, PCI_COR, HERMES_PCI_COR_MASK); |
| mdelay(HERMES_PCI_COR_ONT); |
| |
| /* Give time for the card to recover from this hard effort */ |
| hermes_write_regn(hw, PCI_COR, 0x0000); |
| mdelay(HERMES_PCI_COR_OFFT); |
| |
| /* The card is ready when it's no longer busy */ |
| timeout = jiffies + (HERMES_PCI_COR_BUSYT * HZ / 1000); |
| reg = hermes_read_regn(hw, CMD); |
| while (time_before(jiffies, timeout) && (reg & HERMES_CMD_BUSY)) { |
| mdelay(1); |
| reg = hermes_read_regn(hw, CMD); |
| } |
| |
| /* Still busy? */ |
| if (reg & HERMES_CMD_BUSY) { |
| printk(KERN_ERR PFX "Busy timeout\n"); |
| return -ETIMEDOUT; |
| } |
| |
| return 0; |
| } |
| |
| static int orinoco_pci_init_one(struct pci_dev *pdev, |
| const struct pci_device_id *ent) |
| { |
| int err; |
| struct orinoco_private *priv; |
| struct orinoco_pci_card *card; |
| void __iomem *hermes_io; |
| |
| err = pci_enable_device(pdev); |
| if (err) { |
| printk(KERN_ERR PFX "Cannot enable PCI device\n"); |
| return err; |
| } |
| |
| err = pci_request_regions(pdev, DRIVER_NAME); |
| if (err) { |
| printk(KERN_ERR PFX "Cannot obtain PCI resources\n"); |
| goto fail_resources; |
| } |
| |
| hermes_io = pci_iomap(pdev, 0, 0); |
| if (!hermes_io) { |
| printk(KERN_ERR PFX "Cannot remap chipset registers\n"); |
| err = -EIO; |
| goto fail_map_hermes; |
| } |
| |
| /* Allocate network device */ |
| priv = alloc_orinocodev(sizeof(*card), &pdev->dev, |
| orinoco_pci_cor_reset, NULL); |
| if (!priv) { |
| printk(KERN_ERR PFX "Cannot allocate network device\n"); |
| err = -ENOMEM; |
| goto fail_alloc; |
| } |
| |
| card = priv->card; |
| |
| hermes_struct_init(&priv->hw, hermes_io, HERMES_32BIT_REGSPACING); |
| |
| err = request_irq(pdev->irq, orinoco_interrupt, IRQF_SHARED, |
| DRIVER_NAME, priv); |
| if (err) { |
| printk(KERN_ERR PFX "Cannot allocate IRQ %d\n", pdev->irq); |
| err = -EBUSY; |
| goto fail_irq; |
| } |
| |
| err = orinoco_pci_cor_reset(priv); |
| if (err) { |
| printk(KERN_ERR PFX "Initial reset failed\n"); |
| goto fail; |
| } |
| |
| err = orinoco_init(priv); |
| if (err) { |
| printk(KERN_ERR PFX "orinoco_init() failed\n"); |
| goto fail; |
| } |
| |
| err = orinoco_if_add(priv, 0, 0); |
| if (err) { |
| printk(KERN_ERR PFX "orinoco_if_add() failed\n"); |
| goto fail; |
| } |
| |
| pci_set_drvdata(pdev, priv); |
| |
| return 0; |
| |
| fail: |
| free_irq(pdev->irq, priv); |
| |
| fail_irq: |
| pci_set_drvdata(pdev, NULL); |
| free_orinocodev(priv); |
| |
| fail_alloc: |
| pci_iounmap(pdev, hermes_io); |
| |
| fail_map_hermes: |
| pci_release_regions(pdev); |
| |
| fail_resources: |
| pci_disable_device(pdev); |
| |
| return err; |
| } |
| |
| static void __devexit orinoco_pci_remove_one(struct pci_dev *pdev) |
| { |
| struct orinoco_private *priv = pci_get_drvdata(pdev); |
| |
| orinoco_if_del(priv); |
| free_irq(pdev->irq, priv); |
| pci_set_drvdata(pdev, NULL); |
| free_orinocodev(priv); |
| pci_iounmap(pdev, priv->hw.iobase); |
| pci_release_regions(pdev); |
| pci_disable_device(pdev); |
| } |
| |
| static struct pci_device_id orinoco_pci_id_table[] = { |
| /* Intersil Prism 3 */ |
| {0x1260, 0x3872, PCI_ANY_ID, PCI_ANY_ID,}, |
| /* Intersil Prism 2.5 */ |
| {0x1260, 0x3873, PCI_ANY_ID, PCI_ANY_ID,}, |
| /* Samsung MagicLAN SWL-2210P */ |
| {0x167d, 0xa000, PCI_ANY_ID, PCI_ANY_ID,}, |
| {0,}, |
| }; |
| |
| MODULE_DEVICE_TABLE(pci, orinoco_pci_id_table); |
| |
| static struct pci_driver orinoco_pci_driver = { |
| .name = DRIVER_NAME, |
| .id_table = orinoco_pci_id_table, |
| .probe = orinoco_pci_init_one, |
| .remove = __devexit_p(orinoco_pci_remove_one), |
| .suspend = orinoco_pci_suspend, |
| .resume = orinoco_pci_resume, |
| }; |
| |
| static char version[] __initdata = DRIVER_NAME " " DRIVER_VERSION |
| " (Pavel Roskin <proski@gnu.org>," |
| " David Gibson <hermes@gibson.dropbear.id.au> &" |
| " Jean Tourrilhes <jt@hpl.hp.com>)"; |
| MODULE_AUTHOR("Pavel Roskin <proski@gnu.org> &" |
| " David Gibson <hermes@gibson.dropbear.id.au>"); |
| MODULE_DESCRIPTION("Driver for wireless LAN cards using direct PCI interface"); |
| MODULE_LICENSE("Dual MPL/GPL"); |
| |
| static int __init orinoco_pci_init(void) |
| { |
| printk(KERN_DEBUG "%s\n", version); |
| return pci_register_driver(&orinoco_pci_driver); |
| } |
| |
| static void __exit orinoco_pci_exit(void) |
| { |
| pci_unregister_driver(&orinoco_pci_driver); |
| } |
| |
| module_init(orinoco_pci_init); |
| module_exit(orinoco_pci_exit); |
| |
| /* |
| * Local variables: |
| * c-indent-level: 8 |
| * c-basic-offset: 8 |
| * tab-width: 8 |
| * End: |
| */ |