| /* |
| * Blackfin On-Chip Sport Emulated UART Driver |
| * |
| * Copyright 2006-2008 Analog Devices Inc. |
| * |
| * Enter bugs at http://blackfin.uclinux.org/ |
| * |
| * Licensed under the GPL-2 or later. |
| */ |
| |
| /* |
| * This driver and the hardware supported are in term of EE-191 of ADI. |
| * http://www.analog.com/static/imported-files/application_notes/EE191.pdf |
| * This application note describe how to implement a UART on a Sharc DSP, |
| * but this driver is implemented on Blackfin Processor. |
| * Transmit Frame Sync is not used by this driver to transfer data out. |
| */ |
| |
| #ifndef _BFIN_SPORT_UART_H |
| #define _BFIN_SPORT_UART_H |
| |
| #define OFFSET_TCR1 0x00 /* Transmit Configuration 1 Register */ |
| #define OFFSET_TCR2 0x04 /* Transmit Configuration 2 Register */ |
| #define OFFSET_TCLKDIV 0x08 /* Transmit Serial Clock Divider Register */ |
| #define OFFSET_TFSDIV 0x0C /* Transmit Frame Sync Divider Register */ |
| #define OFFSET_TX 0x10 /* Transmit Data Register */ |
| #define OFFSET_RX 0x18 /* Receive Data Register */ |
| #define OFFSET_RCR1 0x20 /* Receive Configuration 1 Register */ |
| #define OFFSET_RCR2 0x24 /* Receive Configuration 2 Register */ |
| #define OFFSET_RCLKDIV 0x28 /* Receive Serial Clock Divider Register */ |
| #define OFFSET_RFSDIV 0x2c /* Receive Frame Sync Divider Register */ |
| #define OFFSET_STAT 0x30 /* Status Register */ |
| |
| #define SPORT_GET_TCR1(sport) bfin_read16(((sport)->port.membase + OFFSET_TCR1)) |
| #define SPORT_GET_TCR2(sport) bfin_read16(((sport)->port.membase + OFFSET_TCR2)) |
| #define SPORT_GET_TCLKDIV(sport) bfin_read16(((sport)->port.membase + OFFSET_TCLKDIV)) |
| #define SPORT_GET_TFSDIV(sport) bfin_read16(((sport)->port.membase + OFFSET_TFSDIV)) |
| #define SPORT_GET_TX(sport) bfin_read16(((sport)->port.membase + OFFSET_TX)) |
| #define SPORT_GET_RX(sport) bfin_read16(((sport)->port.membase + OFFSET_RX)) |
| /* |
| * If another interrupt fires while doing a 32-bit read from RX FIFO, |
| * a fake RX underflow error will be generated. So disable interrupts |
| * to prevent interruption while reading the FIFO. |
| */ |
| #define SPORT_GET_RX32(sport) \ |
| ({ \ |
| unsigned int __ret; \ |
| unsigned long flags; \ |
| if (ANOMALY_05000473) \ |
| local_irq_save(flags); \ |
| __ret = bfin_read32((sport)->port.membase + OFFSET_RX); \ |
| if (ANOMALY_05000473) \ |
| local_irq_restore(flags); \ |
| __ret; \ |
| }) |
| #define SPORT_GET_RCR1(sport) bfin_read16(((sport)->port.membase + OFFSET_RCR1)) |
| #define SPORT_GET_RCR2(sport) bfin_read16(((sport)->port.membase + OFFSET_RCR2)) |
| #define SPORT_GET_RCLKDIV(sport) bfin_read16(((sport)->port.membase + OFFSET_RCLKDIV)) |
| #define SPORT_GET_RFSDIV(sport) bfin_read16(((sport)->port.membase + OFFSET_RFSDIV)) |
| #define SPORT_GET_STAT(sport) bfin_read16(((sport)->port.membase + OFFSET_STAT)) |
| |
| #define SPORT_PUT_TCR1(sport, v) bfin_write16(((sport)->port.membase + OFFSET_TCR1), v) |
| #define SPORT_PUT_TCR2(sport, v) bfin_write16(((sport)->port.membase + OFFSET_TCR2), v) |
| #define SPORT_PUT_TCLKDIV(sport, v) bfin_write16(((sport)->port.membase + OFFSET_TCLKDIV), v) |
| #define SPORT_PUT_TFSDIV(sport, v) bfin_write16(((sport)->port.membase + OFFSET_TFSDIV), v) |
| #define SPORT_PUT_TX(sport, v) bfin_write16(((sport)->port.membase + OFFSET_TX), v) |
| #define SPORT_PUT_RX(sport, v) bfin_write16(((sport)->port.membase + OFFSET_RX), v) |
| #define SPORT_PUT_RCR1(sport, v) bfin_write16(((sport)->port.membase + OFFSET_RCR1), v) |
| #define SPORT_PUT_RCR2(sport, v) bfin_write16(((sport)->port.membase + OFFSET_RCR2), v) |
| #define SPORT_PUT_RCLKDIV(sport, v) bfin_write16(((sport)->port.membase + OFFSET_RCLKDIV), v) |
| #define SPORT_PUT_RFSDIV(sport, v) bfin_write16(((sport)->port.membase + OFFSET_RFSDIV), v) |
| #define SPORT_PUT_STAT(sport, v) bfin_write16(((sport)->port.membase + OFFSET_STAT), v) |
| |
| #define SPORT_TX_FIFO_SIZE 8 |
| |
| #define SPORT_UART_GET_CTS(x) gpio_get_value(x->cts_pin) |
| #define SPORT_UART_DISABLE_RTS(x) gpio_set_value(x->rts_pin, 1) |
| #define SPORT_UART_ENABLE_RTS(x) gpio_set_value(x->rts_pin, 0) |
| |
| #if defined(CONFIG_SERIAL_BFIN_SPORT0_UART_CTSRTS) \ |
| || defined(CONFIG_SERIAL_BFIN_SPORT1_UART_CTSRTS) \ |
| || defined(CONFIG_SERIAL_BFIN_SPORT2_UART_CTSRTS) \ |
| || defined(CONFIG_SERIAL_BFIN_SPORT3_UART_CTSRTS) |
| # define CONFIG_SERIAL_BFIN_SPORT_CTSRTS |
| #endif |
| |
| #endif /* _BFIN_SPORT_UART_H */ |