blob: 1bd37faba05b9c3aab70a0ec305107f308ba7665 [file] [log] [blame]
USB NOP PHY
Required properties:
- compatible: should be usb-nop-xceiv
Optional properties:
- clocks: phandle to the PHY clock. Use as per Documentation/devicetree
/bindings/clock/clock-bindings.txt
This property is required if clock-frequency is specified.
- clock-names: Should be "main_clk"
- clock-frequency: the clock frequency (in Hz) that the PHY clock must
be configured to.
- vcc-supply: phandle to the regulator that provides RESET to the PHY.
- reset-gpios: Should specify the GPIO for reset.
Example:
hsusb1_phy {
compatible = "usb-nop-xceiv";
clock-frequency = <19200000>;
clocks = <&osc 0>;
clock-names = "main_clk";
vcc-supply = <&hsusb1_vcc_regulator>;
reset-gpios = <&gpio1 7 GPIO_ACTIVE_LOW>;
};
hsusb1_phy is a NOP USB PHY device that gets its clock from an oscillator
and expects that clock to be configured to 19.2MHz by the NOP PHY driver.
hsusb1_vcc_regulator provides power to the PHY and GPIO 7 controls RESET.