| /****************************************************************************** |
| * |
| * This file is provided under a dual BSD/GPLv2 license. When using or |
| * redistributing this file, you may do so under either license. |
| * |
| * GPL LICENSE SUMMARY |
| * |
| * Copyright(c) 2007 - 2014 Intel Corporation. All rights reserved. |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of version 2 of the GNU General Public License as |
| * published by the Free Software Foundation. |
| * |
| * This program is distributed in the hope that it will be useful, but |
| * WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU |
| * General Public License for more details. |
| * |
| * You should have received a copy of the GNU General Public License |
| * along with this program; if not, write to the Free Software |
| * Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA 02110, |
| * USA |
| * |
| * The full GNU General Public License is included in this distribution |
| * in the file called COPYING. |
| * |
| * Contact Information: |
| * Intel Linux Wireless <ilw@linux.intel.com> |
| * Intel Corporation, 5200 N.E. Elam Young Parkway, Hillsboro, OR 97124-6497 |
| * |
| * BSD LICENSE |
| * |
| * Copyright(c) 2005 - 2014 Intel Corporation. All rights reserved. |
| * All rights reserved. |
| * |
| * Redistribution and use in source and binary forms, with or without |
| * modification, are permitted provided that the following conditions |
| * are met: |
| * |
| * * Redistributions of source code must retain the above copyright |
| * notice, this list of conditions and the following disclaimer. |
| * * Redistributions in binary form must reproduce the above copyright |
| * notice, this list of conditions and the following disclaimer in |
| * the documentation and/or other materials provided with the |
| * distribution. |
| * * Neither the name Intel Corporation nor the names of its |
| * contributors may be used to endorse or promote products derived |
| * from this software without specific prior written permission. |
| * |
| * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS |
| * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT |
| * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR |
| * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT |
| * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, |
| * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT |
| * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, |
| * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY |
| * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT |
| * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE |
| * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. |
| * |
| *****************************************************************************/ |
| #ifndef __iwl_op_mode_h__ |
| #define __iwl_op_mode_h__ |
| |
| #include <linux/debugfs.h> |
| |
| struct iwl_op_mode; |
| struct iwl_trans; |
| struct sk_buff; |
| struct iwl_device_cmd; |
| struct iwl_rx_cmd_buffer; |
| struct iwl_fw; |
| struct iwl_cfg; |
| |
| /** |
| * DOC: Operational mode - what is it ? |
| * |
| * The operational mode (a.k.a. op_mode) is the layer that implements |
| * mac80211's handlers. It knows two APIs: mac80211's and the fw's. It uses |
| * the transport API to access the HW. The op_mode doesn't need to know how the |
| * underlying HW works, since the transport layer takes care of that. |
| * |
| * There can be several op_mode: i.e. different fw APIs will require two |
| * different op_modes. This is why the op_mode is virtualized. |
| */ |
| |
| /** |
| * DOC: Life cycle of the Operational mode |
| * |
| * The operational mode has a very simple life cycle. |
| * |
| * 1) The driver layer (iwl-drv.c) chooses the op_mode based on the |
| * capabilities advertized by the fw file (in TLV format). |
| * 2) The driver layer starts the op_mode (ops->start) |
| * 3) The op_mode registers mac80211 |
| * 4) The op_mode is governed by mac80211 |
| * 5) The driver layer stops the op_mode |
| */ |
| |
| /** |
| * struct iwl_op_mode_ops - op_mode specific operations |
| * |
| * The op_mode exports its ops so that external components can start it and |
| * interact with it. The driver layer typically calls the start and stop |
| * handlers, the transport layer calls the others. |
| * |
| * All the handlers MUST be implemented |
| * |
| * @start: start the op_mode. The transport layer is already allocated. |
| * May sleep |
| * @stop: stop the op_mode. Must free all the memory allocated. |
| * May sleep |
| * @rx: Rx notification to the op_mode. rxb is the Rx buffer itself. Cmd is the |
| * HCMD this Rx responds to. |
| * This callback may sleep, it is called from a threaded IRQ handler. |
| * @queue_full: notifies that a HW queue is full. |
| * Must be atomic and called with BH disabled. |
| * @queue_not_full: notifies that a HW queue is not full any more. |
| * Must be atomic and called with BH disabled. |
| * @hw_rf_kill:notifies of a change in the HW rf kill switch. True means that |
| * the radio is killed. Return %true if the device should be stopped by |
| * the transport immediately after the call. May sleep. |
| * @free_skb: allows the transport layer to free skbs that haven't been |
| * reclaimed by the op_mode. This can happen when the driver is freed and |
| * there are Tx packets pending in the transport layer. |
| * Must be atomic |
| * @nic_error: error notification. Must be atomic and must be called with BH |
| * disabled. |
| * @cmd_queue_full: Called when the command queue gets full. Must be atomic and |
| * called with BH disabled. |
| * @nic_config: configure NIC, called before firmware is started. |
| * May sleep |
| * @wimax_active: invoked when WiMax becomes active. May sleep |
| * @enter_d0i3: configure the fw to enter d0i3. May sleep. |
| * @exit_d0i3: configure the fw to exit d0i3. May sleep. |
| */ |
| struct iwl_op_mode_ops { |
| struct iwl_op_mode *(*start)(struct iwl_trans *trans, |
| const struct iwl_cfg *cfg, |
| const struct iwl_fw *fw, |
| struct dentry *dbgfs_dir); |
| void (*stop)(struct iwl_op_mode *op_mode); |
| int (*rx)(struct iwl_op_mode *op_mode, struct iwl_rx_cmd_buffer *rxb, |
| struct iwl_device_cmd *cmd); |
| void (*queue_full)(struct iwl_op_mode *op_mode, int queue); |
| void (*queue_not_full)(struct iwl_op_mode *op_mode, int queue); |
| bool (*hw_rf_kill)(struct iwl_op_mode *op_mode, bool state); |
| void (*free_skb)(struct iwl_op_mode *op_mode, struct sk_buff *skb); |
| void (*nic_error)(struct iwl_op_mode *op_mode); |
| void (*cmd_queue_full)(struct iwl_op_mode *op_mode); |
| void (*nic_config)(struct iwl_op_mode *op_mode); |
| void (*wimax_active)(struct iwl_op_mode *op_mode); |
| int (*enter_d0i3)(struct iwl_op_mode *op_mode); |
| int (*exit_d0i3)(struct iwl_op_mode *op_mode); |
| }; |
| |
| int iwl_opmode_register(const char *name, const struct iwl_op_mode_ops *ops); |
| void iwl_opmode_deregister(const char *name); |
| |
| /** |
| * struct iwl_op_mode - operational mode |
| * @ops: pointer to its own ops |
| * |
| * This holds an implementation of the mac80211 / fw API. |
| */ |
| struct iwl_op_mode { |
| const struct iwl_op_mode_ops *ops; |
| |
| char op_mode_specific[0] __aligned(sizeof(void *)); |
| }; |
| |
| static inline void iwl_op_mode_stop(struct iwl_op_mode *op_mode) |
| { |
| might_sleep(); |
| op_mode->ops->stop(op_mode); |
| } |
| |
| static inline int iwl_op_mode_rx(struct iwl_op_mode *op_mode, |
| struct iwl_rx_cmd_buffer *rxb, |
| struct iwl_device_cmd *cmd) |
| { |
| might_sleep(); |
| return op_mode->ops->rx(op_mode, rxb, cmd); |
| } |
| |
| static inline void iwl_op_mode_queue_full(struct iwl_op_mode *op_mode, |
| int queue) |
| { |
| op_mode->ops->queue_full(op_mode, queue); |
| } |
| |
| static inline void iwl_op_mode_queue_not_full(struct iwl_op_mode *op_mode, |
| int queue) |
| { |
| op_mode->ops->queue_not_full(op_mode, queue); |
| } |
| |
| static inline bool __must_check |
| iwl_op_mode_hw_rf_kill(struct iwl_op_mode *op_mode, bool state) |
| { |
| might_sleep(); |
| return op_mode->ops->hw_rf_kill(op_mode, state); |
| } |
| |
| static inline void iwl_op_mode_free_skb(struct iwl_op_mode *op_mode, |
| struct sk_buff *skb) |
| { |
| op_mode->ops->free_skb(op_mode, skb); |
| } |
| |
| static inline void iwl_op_mode_nic_error(struct iwl_op_mode *op_mode) |
| { |
| op_mode->ops->nic_error(op_mode); |
| } |
| |
| static inline void iwl_op_mode_cmd_queue_full(struct iwl_op_mode *op_mode) |
| { |
| op_mode->ops->cmd_queue_full(op_mode); |
| } |
| |
| static inline void iwl_op_mode_nic_config(struct iwl_op_mode *op_mode) |
| { |
| might_sleep(); |
| op_mode->ops->nic_config(op_mode); |
| } |
| |
| static inline void iwl_op_mode_wimax_active(struct iwl_op_mode *op_mode) |
| { |
| might_sleep(); |
| op_mode->ops->wimax_active(op_mode); |
| } |
| |
| static inline int iwl_op_mode_enter_d0i3(struct iwl_op_mode *op_mode) |
| { |
| might_sleep(); |
| |
| if (!op_mode->ops->enter_d0i3) |
| return 0; |
| return op_mode->ops->enter_d0i3(op_mode); |
| } |
| |
| static inline int iwl_op_mode_exit_d0i3(struct iwl_op_mode *op_mode) |
| { |
| might_sleep(); |
| |
| if (!op_mode->ops->exit_d0i3) |
| return 0; |
| return op_mode->ops->exit_d0i3(op_mode); |
| } |
| |
| #endif /* __iwl_op_mode_h__ */ |