blob: 7cdb505036bb5a02dc85e3bfd76ad1b94baa4154 [file] [log] [blame]
/*
* P1022 DS Device Tree Source stub (no addresses or top-level ranges)
*
* Copyright 2012 Freescale Semiconductor Inc.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions are met:
* * Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* * Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* * Neither the name of Freescale Semiconductor nor the
* names of its contributors may be used to endorse or promote products
* derived from this software without specific prior written permission.
*
*
* ALTERNATIVELY, this software may be distributed under the terms of the
* GNU General Public License ("GPL") as published by the Free Software
* Foundation, either version 2 of that License or (at your option) any
* later version.
*
* THIS SOFTWARE IS PROVIDED BY Freescale Semiconductor "AS IS" AND ANY
* EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
* WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
* DISCLAIMED. IN NO EVENT SHALL Freescale Semiconductor BE LIABLE FOR ANY
* DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
* (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES;
* LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND
* ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS
* SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
&board_lbc {
/*
* This node is used to access the pixis via "indirect" mode,
* which is done by writing the pixis register index to chip
* select 0 and the value to/from chip select 1. Indirect
* mode is the only way to access the pixis when DIU video
* is enabled. Note that this assumes that the first column
* of the 'ranges' property above is the chip select number.
*/
board-control@0,0 {
compatible = "fsl,p1022ds-indirect-pixis";
reg = <0x0 0x0 1 /* CS0 */
0x1 0x0 1>; /* CS1 */
interrupt-parent = <&mpic>;
interrupts = <8 0 0 0>;
};
nor@0,0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "cfi-flash";
reg = <0x0 0x0 0x8000000>;
bank-width = <2>;
device-width = <1>;
partition@0 {
reg = <0x0 0x03000000>;
label = "ramdisk-nor";
read-only;
};
partition@3000000 {
reg = <0x03000000 0x00e00000>;
label = "diagnostic-nor";
read-only;
};
partition@3e00000 {
reg = <0x03e00000 0x00200000>;
label = "dink-nor";
read-only;
};
partition@4000000 {
reg = <0x04000000 0x00400000>;
label = "kernel-nor";
read-only;
};
partition@4400000 {
reg = <0x04400000 0x03b00000>;
label = "jffs2-nor";
};
partition@7f00000 {
reg = <0x07f00000 0x00080000>;
label = "dtb-nor";
read-only;
};
partition@7f80000 {
reg = <0x07f80000 0x00080000>;
label = "u-boot-nor";
read-only;
};
};
nand@2,0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "fsl,elbc-fcm-nand";
reg = <0x2 0x0 0x40000>;
partition@0 {
reg = <0x0 0x02000000>;
label = "u-boot-nand";
read-only;
};
partition@2000000 {
reg = <0x02000000 0x10000000>;
label = "jffs2-nand";
};
partition@12000000 {
reg = <0x12000000 0x10000000>;
label = "ramdisk-nand";
read-only;
};
partition@22000000 {
reg = <0x22000000 0x04000000>;
label = "kernel-nand";
};
partition@26000000 {
reg = <0x26000000 0x01000000>;
label = "dtb-nand";
read-only;
};
partition@27000000 {
reg = <0x27000000 0x19000000>;
label = "reserved-nand";
};
};
board-control@3,0 {
compatible = "fsl,p1022ds-fpga", "fsl,fpga-ngpixis";
reg = <3 0 0x30>;
interrupt-parent = <&mpic>;
/*
* IRQ8 is generated if the "EVENT" switch is pressed
* and PX_CTL[EVESEL] is set to 00.
*/
interrupts = <8 0 0 0>;
};
};
&board_soc {
i2c@3100 {
wm8776:codec@1a {
compatible = "wlf,wm8776";
reg = <0x1a>;
/*
* clock-frequency will be set by U-Boot if
* the clock is enabled.
*/
};
};
spi@7000 {
flash@0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "spansion,s25sl12801";
reg = <0>;
spi-max-frequency = <40000000>; /* input clock */
partition@0 {
label = "u-boot-spi";
reg = <0x00000000 0x00100000>;
read-only;
};
partition@100000 {
label = "kernel-spi";
reg = <0x00100000 0x00500000>;
read-only;
};
partition@600000 {
label = "dtb-spi";
reg = <0x00600000 0x00100000>;
read-only;
};
partition@700000 {
label = "file system-spi";
reg = <0x00700000 0x00900000>;
};
};
};
ssi@15000 {
fsl,mode = "i2s-slave";
codec-handle = <&wm8776>;
fsl,ssi-asynchronous;
};
usb@22000 {
phy_type = "ulpi";
};
usb@23000 {
status = "disabled";
};
mdio@24000 {
phy0: ethernet-phy@0 {
interrupts = <3 1 0 0>;
reg = <0x1>;
};
phy1: ethernet-phy@1 {
interrupts = <9 1 0 0>;
reg = <0x2>;
};
tbi-phy@2 {
device_type = "tbi-phy";
reg = <0x2>;
};
};
ethernet@b0000 {
phy-handle = <&phy0>;
phy-connection-type = "rgmii-id";
};
ethernet@b1000 {
phy-handle = <&phy1>;
phy-connection-type = "rgmii-id";
};
};