| Here are a few quick points about DECnet support... |
| o iproute2 is the tool of choice for configuring the DECnet support for |
| Linux. For many features, it is the only tool which can be used to |
| o No name resolution is available as yet, all addresses must be |
| o Remember to set the hardware address of the interface using: |
| ip link set ethX address xx:xx:xx:xx:xx:xx |
| (where xx:xx:xx:xx:xx:xx is the MAC address for your DECnet node |
| if your Ethernet card won't listen to more than one unicast |
| mac address at once. If the Linux DECnet stack doesn't talk to |
| any other DECnet nodes, then check this with tcpdump and if its |
| a problem, change the mac address (but do this _before_ starting |
| any other network protocol on the interface) |
| o Whilst you can use ip addr add to add more than one DECnet address to an |
| interface, don't expect addresses which are not the same as the |
| kernels node address to work properly with 2.4 kernels. This should |
| be fine with 2.6 kernels as the routing code has been extensively |
| o The DECnet support is currently self contained. It does not depend on |
| Steve Whitehouse <steve@chygwyn.com> |