* Texas Instruments Davinci NAND

This file provides information, what the device node for the
davinci nand interface contain.

Required properties:
- compatible: "ti,davinci-nand";
- reg : contain 2 offset/length values:
        - offset and length for the access window
        - offset and length for accessing the aemif control registers
- ti,davinci-chipselect: Indicates on the davinci_nand driver which
                         chipselect is used for accessing the nand.

Recommended properties :
- ti,davinci-mask-ale: mask for ale
- ti,davinci-mask-cle: mask for cle
- ti,davinci-mask-chipsel: mask for chipselect
- ti,davinci-ecc-mode: ECC mode valid values for davinci driver:
		- "none"
		- "soft"
		- "hw"
- ti,davinci-ecc-bits: used ECC bits, currently supported 1 or 4.
- ti,davinci-nand-buswidth: buswidth 8 or 16
- ti,davinci-nand-use-bbt: use flash based bad block table support.

Example (enbw_cmc board):
aemif@60000000 {
	compatible = "ti,davinci-aemif";
	#address-cells = <2>;
	#size-cells = <1>;
	reg = <0x68000000 0x80000>;
	ranges = <2 0 0x60000000 0x02000000
		  3 0 0x62000000 0x02000000
		  4 0 0x64000000 0x02000000
		  5 0 0x66000000 0x02000000
		  6 0 0x68000000 0x02000000>;
	nand@3,0 {
		compatible = "ti,davinci-nand";
		reg = <3 0x0 0x807ff
			6 0x0 0x8000>;
		#address-cells = <1>;
		#size-cells = <1>;
		ti,davinci-chipselect = <1>;
		ti,davinci-mask-ale = <0>;
		ti,davinci-mask-cle = <0>;
		ti,davinci-mask-chipsel = <0>;
		ti,davinci-ecc-mode = "hw";
		ti,davinci-ecc-bits = <4>;
		ti,davinci-nand-use-bbt;
	};
};