/*
 * drivers/usb/host/ehci-orion.c
 *
 * Tzachi Perelstein <tzachi@marvell.com>
 *
 * This file is licensed under  the terms of the GNU General Public
 * License version 2. This program is licensed "as is" without any
 * warranty of any kind, whether express or implied.
 */

#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/platform_device.h>
#include <linux/mbus.h>
#include <linux/clk.h>
#include <linux/platform_data/usb-ehci-orion.h>
#include <linux/of.h>
#include <linux/of_device.h>
#include <linux/of_irq.h>

#define rdl(off)	__raw_readl(hcd->regs + (off))
#define wrl(off, val)	__raw_writel((val), hcd->regs + (off))

#define USB_CMD			0x140
#define USB_MODE		0x1a8
#define USB_CAUSE		0x310
#define USB_MASK		0x314
#define USB_WINDOW_CTRL(i)	(0x320 + ((i) << 4))
#define USB_WINDOW_BASE(i)	(0x324 + ((i) << 4))
#define USB_IPG			0x360
#define USB_PHY_PWR_CTRL	0x400
#define USB_PHY_TX_CTRL		0x420
#define USB_PHY_RX_CTRL		0x430
#define USB_PHY_IVREF_CTRL	0x440
#define USB_PHY_TST_GRP_CTRL	0x450

/*
 * Implement Orion USB controller specification guidelines
 */
static void orion_usb_phy_v1_setup(struct usb_hcd *hcd)
{
	/* The below GLs are according to the Orion Errata document */
	/*
	 * Clear interrupt cause and mask
	 */
	wrl(USB_CAUSE, 0);
	wrl(USB_MASK, 0);

	/*
	 * Reset controller
	 */
	wrl(USB_CMD, rdl(USB_CMD) | 0x2);
	while (rdl(USB_CMD) & 0x2);

	/*
	 * GL# USB-10: Set IPG for non start of frame packets
	 * Bits[14:8]=0xc
	 */
	wrl(USB_IPG, (rdl(USB_IPG) & ~0x7f00) | 0xc00);

	/*
	 * GL# USB-9: USB 2.0 Power Control
	 * BG_VSEL[7:6]=0x1
	 */
	wrl(USB_PHY_PWR_CTRL, (rdl(USB_PHY_PWR_CTRL) & ~0xc0)| 0x40);

	/*
	 * GL# USB-1: USB PHY Tx Control - force calibration to '8'
	 * TXDATA_BLOCK_EN[21]=0x1, EXT_RCAL_EN[13]=0x1, IMP_CAL[6:3]=0x8
	 */
	wrl(USB_PHY_TX_CTRL, (rdl(USB_PHY_TX_CTRL) & ~0x78) | 0x202040);

	/*
	 * GL# USB-3 GL# USB-9: USB PHY Rx Control
	 * RXDATA_BLOCK_LENGHT[31:30]=0x3, EDGE_DET_SEL[27:26]=0,
	 * CDR_FASTLOCK_EN[21]=0, DISCON_THRESHOLD[9:8]=0, SQ_THRESH[7:4]=0x1
	 */
	wrl(USB_PHY_RX_CTRL, (rdl(USB_PHY_RX_CTRL) & ~0xc2003f0) | 0xc0000010);

	/*
	 * GL# USB-3 GL# USB-9: USB PHY IVREF Control
	 * PLLVDD12[1:0]=0x2, RXVDD[5:4]=0x3, Reserved[19]=0
	 */
	wrl(USB_PHY_IVREF_CTRL, (rdl(USB_PHY_IVREF_CTRL) & ~0x80003 ) | 0x32);

	/*
	 * GL# USB-3 GL# USB-9: USB PHY Test Group Control
	 * REG_FIFO_SQ_RST[15]=0
	 */
	wrl(USB_PHY_TST_GRP_CTRL, rdl(USB_PHY_TST_GRP_CTRL) & ~0x8000);

	/*
	 * Stop and reset controller
	 */
	wrl(USB_CMD, rdl(USB_CMD) & ~0x1);
	wrl(USB_CMD, rdl(USB_CMD) | 0x2);
	while (rdl(USB_CMD) & 0x2);

	/*
	 * GL# USB-5 Streaming disable REG_USB_MODE[4]=1
	 * TBD: This need to be done after each reset!
	 * GL# USB-4 Setup USB Host mode
	 */
	wrl(USB_MODE, 0x13);
}

static const struct hc_driver ehci_orion_hc_driver = {
	.description = hcd_name,
	.product_desc = "Marvell Orion EHCI",
	.hcd_priv_size = sizeof(struct ehci_hcd),

	/*
	 * generic hardware linkage
	 */
	.irq = ehci_irq,
	.flags = HCD_MEMORY | HCD_USB2,

	/*
	 * basic lifecycle operations
	 */
	.reset = ehci_setup,
	.start = ehci_run,
	.stop = ehci_stop,
	.shutdown = ehci_shutdown,

	/*
	 * managing i/o requests and associated device resources
	 */
	.urb_enqueue = ehci_urb_enqueue,
	.urb_dequeue = ehci_urb_dequeue,
	.endpoint_disable = ehci_endpoint_disable,
	.endpoint_reset = ehci_endpoint_reset,

	/*
	 * scheduling support
	 */
	.get_frame_number = ehci_get_frame,

	/*
	 * root hub support
	 */
	.hub_status_data = ehci_hub_status_data,
	.hub_control = ehci_hub_control,
	.bus_suspend = ehci_bus_suspend,
	.bus_resume = ehci_bus_resume,
	.relinquish_port = ehci_relinquish_port,
	.port_handed_over = ehci_port_handed_over,

	.clear_tt_buffer_complete = ehci_clear_tt_buffer_complete,
};

static void
ehci_orion_conf_mbus_windows(struct usb_hcd *hcd,
			     const struct mbus_dram_target_info *dram)
{
	int i;

	for (i = 0; i < 4; i++) {
		wrl(USB_WINDOW_CTRL(i), 0);
		wrl(USB_WINDOW_BASE(i), 0);
	}

	for (i = 0; i < dram->num_cs; i++) {
		const struct mbus_dram_window *cs = dram->cs + i;

		wrl(USB_WINDOW_CTRL(i), ((cs->size - 1) & 0xffff0000) |
					(cs->mbus_attr << 8) |
					(dram->mbus_dram_target_id << 4) | 1);
		wrl(USB_WINDOW_BASE(i), cs->base);
	}
}

static u64 ehci_orion_dma_mask = DMA_BIT_MASK(32);

static int ehci_orion_drv_probe(struct platform_device *pdev)
{
	struct orion_ehci_data *pd = pdev->dev.platform_data;
	const struct mbus_dram_target_info *dram;
	struct resource *res;
	struct usb_hcd *hcd;
	struct ehci_hcd *ehci;
	struct clk *clk;
	void __iomem *regs;
	int irq, err;
	enum orion_ehci_phy_ver phy_version;

	if (usb_disabled())
		return -ENODEV;

	pr_debug("Initializing Orion-SoC USB Host Controller\n");

	if (pdev->dev.of_node)
		irq = irq_of_parse_and_map(pdev->dev.of_node, 0);
	else
		irq = platform_get_irq(pdev, 0);
	if (irq <= 0) {
		dev_err(&pdev->dev,
			"Found HC with no IRQ. Check %s setup!\n",
			dev_name(&pdev->dev));
		err = -ENODEV;
		goto err1;
	}

	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
	if (!res) {
		dev_err(&pdev->dev,
			"Found HC with no register addr. Check %s setup!\n",
			dev_name(&pdev->dev));
		err = -ENODEV;
		goto err1;
	}

	/*
	 * Right now device-tree probed devices don't get dma_mask
	 * set. Since shared usb code relies on it, set it here for
	 * now. Once we have dma capability bindings this can go away.
	 */
	if (!pdev->dev.dma_mask)
		pdev->dev.dma_mask = &ehci_orion_dma_mask;

	if (!request_mem_region(res->start, resource_size(res),
				ehci_orion_hc_driver.description)) {
		dev_dbg(&pdev->dev, "controller already in use\n");
		err = -EBUSY;
		goto err1;
	}

	regs = ioremap(res->start, resource_size(res));
	if (regs == NULL) {
		dev_dbg(&pdev->dev, "error mapping memory\n");
		err = -EFAULT;
		goto err2;
	}

	/* Not all platforms can gate the clock, so it is not
	   an error if the clock does not exists. */
	clk = clk_get(&pdev->dev, NULL);
	if (!IS_ERR(clk)) {
		clk_prepare_enable(clk);
		clk_put(clk);
	}

	hcd = usb_create_hcd(&ehci_orion_hc_driver,
			&pdev->dev, dev_name(&pdev->dev));
	if (!hcd) {
		err = -ENOMEM;
		goto err3;
	}

	hcd->rsrc_start = res->start;
	hcd->rsrc_len = resource_size(res);
	hcd->regs = regs;

	ehci = hcd_to_ehci(hcd);
	ehci->caps = hcd->regs + 0x100;
	hcd->has_tt = 1;

	/*
	 * (Re-)program MBUS remapping windows if we are asked to.
	 */
	dram = mv_mbus_dram_info();
	if (dram)
		ehci_orion_conf_mbus_windows(hcd, dram);

	/*
	 * setup Orion USB controller.
	 */
	if (pdev->dev.of_node)
		phy_version = EHCI_PHY_NA;
	else
		phy_version = pd->phy_version;

	switch (phy_version) {
	case EHCI_PHY_NA:	/* dont change USB phy settings */
		break;
	case EHCI_PHY_ORION:
		orion_usb_phy_v1_setup(hcd);
		break;
	case EHCI_PHY_DD:
	case EHCI_PHY_KW:
	default:
		printk(KERN_WARNING "Orion ehci -USB phy version isn't supported.\n");
	}

	err = usb_add_hcd(hcd, irq, IRQF_SHARED);
	if (err)
		goto err4;

	return 0;

err4:
	usb_put_hcd(hcd);
err3:
	if (!IS_ERR(clk)) {
		clk_disable_unprepare(clk);
		clk_put(clk);
	}
	iounmap(regs);
err2:
	release_mem_region(res->start, resource_size(res));
err1:
	dev_err(&pdev->dev, "init %s fail, %d\n",
		dev_name(&pdev->dev), err);

	return err;
}

static int __exit ehci_orion_drv_remove(struct platform_device *pdev)
{
	struct usb_hcd *hcd = platform_get_drvdata(pdev);
	struct clk *clk;

	usb_remove_hcd(hcd);
	iounmap(hcd->regs);
	release_mem_region(hcd->rsrc_start, hcd->rsrc_len);
	usb_put_hcd(hcd);

	clk = clk_get(&pdev->dev, NULL);
	if (!IS_ERR(clk)) {
		clk_disable_unprepare(clk);
		clk_put(clk);
	}
	return 0;
}

MODULE_ALIAS("platform:orion-ehci");

static const struct of_device_id ehci_orion_dt_ids[] = {
	{ .compatible = "marvell,orion-ehci", },
	{},
};
MODULE_DEVICE_TABLE(of, ehci_orion_dt_ids);

static struct platform_driver ehci_orion_driver = {
	.probe		= ehci_orion_drv_probe,
	.remove		= __exit_p(ehci_orion_drv_remove),
	.shutdown	= usb_hcd_platform_shutdown,
	.driver = {
		.name	= "orion-ehci",
		.owner  = THIS_MODULE,
		.of_match_table = of_match_ptr(ehci_orion_dt_ids),
	},
};