x86: PAT phys_mem_access_prot_allowed for dev/mem mmap
Introduce phys_mem_access_prot_allowed(), which checks whether the mapping
is possible, without any conflicts and returns success or failure based on that.
phys_mem_access_prot() by itself does not allow failure case. This ability
to return error is needed for PAT where we may have aliasing conflicts.
x86 setup __HAVE_PHYS_MEM_ACCESS_PROT and move x86 specific code out of
/dev/mem into arch specific area.
Signed-off-by: Venkatesh Pallipadi <venkatesh.pallipadi@intel.com>
Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
diff --git a/arch/x86/mm/pat.c b/arch/x86/mm/pat.c
index 72c0f60..64cc0c1 100644
--- a/arch/x86/mm/pat.c
+++ b/arch/x86/mm/pat.c
@@ -419,3 +419,42 @@
return err;
}
+
+/* /dev/mem interface. Use the previous mapping */
+pgprot_t phys_mem_access_prot(struct file *file, unsigned long pfn,
+ unsigned long size, pgprot_t vma_prot)
+{
+ return vma_prot;
+}
+
+int phys_mem_access_prot_allowed(struct file *file, unsigned long pfn,
+ unsigned long size, pgprot_t *vma_prot)
+{
+
+ if (file->f_flags & O_SYNC) {
+ *vma_prot = pgprot_noncached(*vma_prot);
+ return 1;
+ }
+
+#ifdef CONFIG_X86_32
+ /*
+ * On the PPro and successors, the MTRRs are used to set
+ * memory types for physical addresses outside main memory,
+ * so blindly setting UC or PWT on those pages is wrong.
+ * For Pentiums and earlier, the surround logic should disable
+ * caching for the high addresses through the KEN pin, but
+ * we maintain the tradition of paranoia in this code.
+ */
+ if (!pat_wc_enabled &&
+ ! ( test_bit(X86_FEATURE_MTRR, boot_cpu_data.x86_capability) ||
+ test_bit(X86_FEATURE_K6_MTRR, boot_cpu_data.x86_capability) ||
+ test_bit(X86_FEATURE_CYRIX_ARR, boot_cpu_data.x86_capability) ||
+ test_bit(X86_FEATURE_CENTAUR_MCR, boot_cpu_data.x86_capability)) &&
+ (pfn << PAGE_SHIFT) >= __pa(high_memory)) {
+ *vma_prot = pgprot_noncached(*vma_prot);
+ return 1;
+ }
+#endif
+
+ return 1;
+}
