agp: use dev_printk when possible
Convert printks to use dev_printk().
Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Dave Airlie <airlied@redhat.com>
diff --git a/drivers/char/agp/sworks-agp.c b/drivers/char/agp/sworks-agp.c
index 0e054c1..2fb27fe 100644
--- a/drivers/char/agp/sworks-agp.c
+++ b/drivers/char/agp/sworks-agp.c
@@ -241,7 +241,8 @@
while (readb(serverworks_private.registers+SVWRKS_POSTFLUSH) == 1) {
cpu_relax();
if (time_after(jiffies, timeout)) {
- printk(KERN_ERR PFX "TLB post flush took more than 3 seconds\n");
+ dev_err(&serverworks_private.svrwrks_dev->dev,
+ "TLB post flush took more than 3 seconds\n");
break;
}
}
@@ -251,7 +252,8 @@
while (readl(serverworks_private.registers+SVWRKS_DIRFLUSH) == 1) {
cpu_relax();
if (time_after(jiffies, timeout)) {
- printk(KERN_ERR PFX "TLB Dir flush took more than 3 seconds\n");
+ dev_err(&serverworks_private.svrwrks_dev->dev,
+ "TLB Dir flush took more than 3 seconds\n");
break;
}
}
@@ -271,7 +273,7 @@
temp = (temp & PCI_BASE_ADDRESS_MEM_MASK);
serverworks_private.registers = (volatile u8 __iomem *) ioremap(temp, 4096);
if (!serverworks_private.registers) {
- printk (KERN_ERR PFX "Unable to ioremap() memory.\n");
+ dev_err(&agp_bridge->dev->dev, "can't ioremap(%#x)\n", temp);
return -ENOMEM;
}
@@ -451,7 +453,7 @@
switch (pdev->device) {
case 0x0006:
- printk (KERN_ERR PFX "ServerWorks CNB20HE is unsupported due to lack of documentation.\n");
+ dev_err(&pdev->dev, "ServerWorks CNB20HE is unsupported due to lack of documentation\n");
return -ENODEV;
case PCI_DEVICE_ID_SERVERWORKS_HE:
@@ -461,8 +463,8 @@
default:
if (cap_ptr)
- printk(KERN_ERR PFX "Unsupported Serverworks chipset "
- "(device id: %04x)\n", pdev->device);
+ dev_err(&pdev->dev, "unsupported Serverworks chipset "
+ "[%04x/%04x]\n", pdev->vendor, pdev->device);
return -ENODEV;
}
@@ -470,8 +472,7 @@
bridge_dev = pci_get_bus_and_slot((unsigned int)pdev->bus->number,
PCI_DEVFN(0, 1));
if (!bridge_dev) {
- printk(KERN_INFO PFX "Detected a Serverworks chipset "
- "but could not find the secondary device.\n");
+ dev_info(&pdev->dev, "can't find secondary device\n");
return -ENODEV;
}
@@ -482,8 +483,8 @@
if (temp & PCI_BASE_ADDRESS_MEM_TYPE_64) {
pci_read_config_dword(pdev, SVWRKS_APSIZE + 4, &temp2);
if (temp2 != 0) {
- printk(KERN_INFO PFX "Detected 64 bit aperture address, "
- "but top bits are not zero. Disabling agp\n");
+ dev_info(&pdev->dev, "64 bit aperture address, "
+ "but top bits are not zero; disabling AGP\n");
return -ENODEV;
}
serverworks_private.mm_addr_ofs = 0x18;
@@ -495,8 +496,8 @@
pci_read_config_dword(pdev,
serverworks_private.mm_addr_ofs + 4, &temp2);
if (temp2 != 0) {
- printk(KERN_INFO PFX "Detected 64 bit MMIO address, "
- "but top bits are not zero. Disabling agp\n");
+ dev_info(&pdev->dev, "64 bit MMIO address, but top "
+ "bits are not zero; disabling AGP\n");
return -ENODEV;
}
}
