Btrfs: stop silently switching single chunks to raid0 on balance
This has been causing a lot of confusion for quite a while now and a lot
of users were surprised by this (some of them were even stuck in a
ENOSPC situation which they couldn't easily get out of). The addition
of restriper gives users a clear choice between raid0 and drive concat
setup so there's absolutely no excuse for us to keep doing this.
Signed-off-by: Ilya Dryomov <idryomov@gmail.com>
diff --git a/fs/btrfs/extent-tree.c b/fs/btrfs/extent-tree.c
index 1b831ac..4269777 100644
--- a/fs/btrfs/extent-tree.c
+++ b/fs/btrfs/extent-tree.c
@@ -6941,7 +6941,6 @@
if (flags & (BTRFS_BLOCK_GROUP_RAID1 |
BTRFS_BLOCK_GROUP_RAID10))
return stripped | BTRFS_BLOCK_GROUP_DUP;
- return flags;
} else {
/* they already had raid on here, just return */
if (flags & stripped)
@@ -6954,9 +6953,9 @@
if (flags & BTRFS_BLOCK_GROUP_DUP)
return stripped | BTRFS_BLOCK_GROUP_RAID1;
- /* turn single device chunks into raid0 */
- return stripped | BTRFS_BLOCK_GROUP_RAID0;
+ /* this is drive concat, leave it alone */
}
+
return flags;
}
