ath9k: always issue a full hw reset after waking up from full-sleep mode
After waking up from full sleep, registers are accessible, but rx/tx
typically fails. A fast channel change will not recover from this, so
ensure that a full-sleep -> wake transition is always followed by a full
reset.
The reason why this hasn't created any serious problems yet is that it's
hidden by the (wrong) behavior of enabling/disabling the radio when the
wiphy idle state changes.
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/xmit.c b/drivers/net/wireless/ath/ath9k/xmit.c
index 80639e3..9e65c31 100644
--- a/drivers/net/wireless/ath/ath9k/xmit.c
+++ b/drivers/net/wireless/ath/ath9k/xmit.c
@@ -1954,7 +1954,7 @@
skb_pull(skb, padsize);
}
- if (sc->ps_flags & PS_WAIT_FOR_TX_ACK) {
+ if ((sc->ps_flags & PS_WAIT_FOR_TX_ACK) && !txq->axq_depth) {
sc->ps_flags &= ~PS_WAIT_FOR_TX_ACK;
ath_dbg(common, ATH_DBG_PS,
"Going back to sleep after having received TX status (0x%lx)\n",
