[SPARC64]: In sunsab driver, make sure to set the uart timeout.
This breaks serial consoles badly. Thanks to Eric Brower
for tracking down the problem.
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/serial/sunsab.c b/drivers/serial/sunsab.c
index 8caaf2e..39b788d 100644
--- a/drivers/serial/sunsab.c
+++ b/drivers/serial/sunsab.c
@@ -682,7 +682,8 @@
/* Internal routine, port->lock is held and local interrupts are disabled. */
static void sunsab_convert_to_sab(struct uart_sunsab_port *up, unsigned int cflag,
- unsigned int iflag, int baud)
+ unsigned int iflag, unsigned int baud,
+ unsigned int quot)
{
unsigned int ebrg;
unsigned char dafo;
@@ -766,6 +767,9 @@
up->port.ignore_status_mask |= (SAB82532_ISR0_RPF |
SAB82532_ISR0_TCD);
+ uart_update_timeout(&up->port, cflag,
+ (up->port.uartclk / (16 * quot)));
+
/* Now bang the new settings into the chip. */
sunsab_cec_wait(up);
sunsab_tec_wait(up);
@@ -784,10 +788,11 @@
{
struct uart_sunsab_port *up = (struct uart_sunsab_port *) port;
unsigned long flags;
- int baud = uart_get_baud_rate(port, termios, old, 0, 4000000);
+ unsigned int baud = uart_get_baud_rate(port, termios, old, 0, 4000000);
+ unsigned int quot = uart_get_divisor(port, baud);
spin_lock_irqsave(&up->port.lock, flags);
- sunsab_convert_to_sab(up, termios->c_cflag, termios->c_iflag, baud);
+ sunsab_convert_to_sab(up, termios->c_cflag, termios->c_iflag, baud, quot);
spin_unlock_irqrestore(&up->port.lock, flags);
}
@@ -880,7 +885,7 @@
{
struct uart_sunsab_port *up = &sunsab_ports[con->index];
unsigned long flags;
- int baud;
+ unsigned int baud, quot;
printk("Console: ttyS%d (SAB82532)\n",
(sunsab_reg.minor - 64) + con->index);
@@ -926,7 +931,8 @@
SAB82532_IMR1_XPR;
writeb(up->interrupt_mask1, &up->regs->w.imr1);
- sunsab_convert_to_sab(up, con->cflag, 0, baud);
+ quot = uart_get_divisor(&up->port, baud);
+ sunsab_convert_to_sab(up, con->cflag, 0, baud, quot);
sunsab_set_mctrl(&up->port, TIOCM_DTR | TIOCM_RTS);
spin_unlock_irqrestore(&up->port.lock, flags);
