[PATCH] m68k: convert mac irq code
Signed-off-by: Roman Zippel <zippel@linux-m68k.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/scsi/mac_scsi.c b/drivers/scsi/mac_scsi.c
index 777f9bc..a942a21 100644
--- a/drivers/scsi/mac_scsi.c
+++ b/drivers/scsi/mac_scsi.c
@@ -65,9 +65,6 @@
#define RESET_BOOT
#define DRIVER_SETUP
-#define ENABLE_IRQ() mac_enable_irq( IRQ_MAC_SCSI );
-#define DISABLE_IRQ() mac_disable_irq( IRQ_MAC_SCSI );
-
extern void via_scsi_clear(void);
#ifdef RESET_BOOT
@@ -351,7 +348,7 @@
printk(KERN_INFO "Macintosh SCSI: resetting the SCSI bus..." );
/* switch off SCSI IRQ - catch an interrupt without IRQ bit set else */
- mac_disable_irq(IRQ_MAC_SCSI);
+ disable_irq(IRQ_MAC_SCSI);
/* get in phase */
NCR5380_write( TARGET_COMMAND_REG,
@@ -369,7 +366,7 @@
barrier();
/* switch on SCSI IRQ again */
- mac_enable_irq(IRQ_MAC_SCSI);
+ enable_irq(IRQ_MAC_SCSI);
printk(KERN_INFO " done\n" );
}
