I/OAT: fail initialization on zero channels detection
On some systems with I/OAT ver.2 when DCA is disabled in BIOS
situations have been observed
that zero DMA channels are detected instead of four.
To avoid kernel panic driver should fail gracefully with appropriate message.
Signed-off-by: Maciej Sosnowski <maciej.sosnowski@intel.com>
Signed-off-by: Shannon Nelson <shannon.nelson@intel.com>
Acked-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Dan Williams <dan.j.williams@intel.com>
diff --git a/drivers/dma/ioat_dma.c b/drivers/dma/ioat_dma.c
index 879f4a0..9012da7 100644
--- a/drivers/dma/ioat_dma.c
+++ b/drivers/dma/ioat_dma.c
@@ -1659,6 +1659,13 @@
" %d channels, device version 0x%02x, driver version %s\n",
device->common.chancnt, device->version, IOAT_DMA_VERSION);
+ if (!device->common.chancnt) {
+ dev_err(&device->pdev->dev,
+ "Intel(R) I/OAT DMA Engine problem found: "
+ "zero channels detected\n");
+ goto err_setup_interrupts;
+ }
+
err = ioat_dma_setup_interrupts(device);
if (err)
goto err_setup_interrupts;
