spi/dw_spi: remove the un-necessary flush()
The flush() is used to drain all the left data in rx fifo, currently
is is always called together with disabling hw. But from spec, disabling
hw will also reset all the fifo, so flush() is not needed.
Signed-off-by: Alek Du <alek.du@intel.com>
Signed-off-by: Feng Tang <feng.tang@intel.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/spi/dw_spi.c b/drivers/spi/dw_spi.c
index c4fca3d..d3aaf8d 100644
--- a/drivers/spi/dw_spi.c
+++ b/drivers/spi/dw_spi.c
@@ -173,17 +173,6 @@
"DW SPI: Status keeps busy for 5000us after a read/write!\n");
}
-static void flush(struct dw_spi *dws)
-{
- while (dw_readw(dws, sr) & SR_RF_NOT_EMPT) {
- dw_readw(dws, dr);
- cpu_relax();
- }
-
- wait_till_not_busy(dws);
-}
-
-
static int dw_writer(struct dw_spi *dws)
{
u16 txw = 0;
@@ -297,8 +286,7 @@
static void int_error_stop(struct dw_spi *dws, const char *msg)
{
- /* Stop and reset hw */
- flush(dws);
+ /* Stop the hw */
spi_enable_chip(dws, 0);
dev_err(&dws->master->dev, "%s\n", msg);
@@ -800,7 +788,6 @@
spi_enable_chip(dws, 0);
spi_mask_intr(dws, 0xff);
spi_enable_chip(dws, 1);
- flush(dws);
/*
* Try to detect the FIFO depth if not set by interface driver,
