cxgb2: convert to net_device_ops
Convert this driver to network device ops. Compile teseted only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/chelsio/cxgb2.c b/drivers/net/chelsio/cxgb2.c
index 5fb0038..4827417 100644
--- a/drivers/net/chelsio/cxgb2.c
+++ b/drivers/net/chelsio/cxgb2.c
@@ -1010,6 +1010,23 @@
adapter->name);
}
+static const struct net_device_ops cxgb_netdev_ops = {
+ .ndo_open = cxgb_open,
+ .ndo_stop = cxgb_close,
+ .ndo_get_stats = t1_get_stats,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_multicast_list = t1_set_rxmode,
+ .ndo_do_ioctl = t1_ioctl,
+ .ndo_change_mtu = t1_change_mtu,
+ .ndo_set_mac_address = t1_set_mac_addr,
+#if defined(CONFIG_VLAN_8021Q) || defined(CONFIG_VLAN_8021Q_MODULE)
+ .ndo_vlan_rx_register = vlan_rx_register,
+#endif
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = t1_netpoll,
+#endif
+};
+
static int __devinit init_one(struct pci_dev *pdev,
const struct pci_device_id *ent)
{
@@ -1130,7 +1147,6 @@
adapter->flags |= VLAN_ACCEL_CAPABLE;
netdev->features |=
NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX;
- netdev->vlan_rx_register = vlan_rx_register;
#endif
/* T204: disable TSO */
@@ -1140,19 +1156,11 @@
}
}
- netdev->open = cxgb_open;
- netdev->stop = cxgb_close;
+ netdev->netdev_ops = &cxgb_netdev_ops;
netdev->hard_start_xmit = t1_start_xmit;
netdev->hard_header_len += (adapter->flags & TSO_CAPABLE) ?
sizeof(struct cpl_tx_pkt_lso) : sizeof(struct cpl_tx_pkt);
- netdev->get_stats = t1_get_stats;
- netdev->set_multicast_list = t1_set_rxmode;
- netdev->do_ioctl = t1_ioctl;
- netdev->change_mtu = t1_change_mtu;
- netdev->set_mac_address = t1_set_mac_addr;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- netdev->poll_controller = t1_netpoll;
-#endif
+
netif_napi_add(netdev, &adapter->napi, t1_poll, 64);
SET_ETHTOOL_OPS(netdev, &t1_ethtool_ops);
