[PATCH] cris v10 eth: use ethtool_ops
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
diff --git a/drivers/net/cris/eth_v10.c b/drivers/net/cris/eth_v10.c
index b68b9ca..64105e4 100644
--- a/drivers/net/cris/eth_v10.c
+++ b/drivers/net/cris/eth_v10.c
@@ -409,7 +409,6 @@
static void e100_rx(struct net_device *dev);
static int e100_close(struct net_device *dev);
static int e100_ioctl(struct net_device *dev, struct ifreq *ifr, int cmd);
-static int e100_ethtool_ioctl(struct net_device* dev, struct ifreq *ifr);
static int e100_set_config(struct net_device* dev, struct ifmap* map);
static void e100_tx_timeout(struct net_device *dev);
static struct net_device_stats *e100_get_stats(struct net_device *dev);
@@ -436,6 +435,8 @@
static void e100_clear_network_leds(unsigned long dummy);
static void e100_set_network_leds(int active);
+static struct ethtool_ops e100_ethtool_ops;
+
static void broadcom_check_speed(struct net_device* dev);
static void broadcom_check_duplex(struct net_device* dev);
static void tdk_check_speed(struct net_device* dev);
@@ -495,6 +496,7 @@
dev->get_stats = e100_get_stats;
dev->set_multicast_list = set_multicast_list;
dev->set_mac_address = e100_set_mac_address;
+ dev->ethtool_ops = &e100_ethtool_ops;
dev->do_ioctl = e100_ioctl;
dev->set_config = e100_set_config;
dev->tx_timeout = e100_tx_timeout;
@@ -1448,8 +1450,6 @@
spin_lock(&np->lock); /* Preempt protection */
switch (cmd) {
- case SIOCETHTOOL:
- return e100_ethtool_ioctl(dev,ifr);
case SIOCGMIIPHY: /* Get PHY address */
data->phy_id = mdio_phy_addr;
break;
@@ -1486,88 +1486,81 @@
return 0;
}
-static int
-e100_ethtool_ioctl(struct net_device *dev, struct ifreq *ifr)
+static int e100_set_settings(struct net_device *dev,
+ struct ethtool_cmd *ecmd)
{
- struct ethtool_cmd ecmd;
-
- if (copy_from_user(&ecmd, ifr->ifr_data, sizeof (ecmd)))
- return -EFAULT;
-
- switch (ecmd.cmd) {
- case ETHTOOL_GSET:
- {
- memset((void *) &ecmd, 0, sizeof (ecmd));
- ecmd.supported =
- SUPPORTED_Autoneg | SUPPORTED_TP | SUPPORTED_MII |
+ ecmd->supported = SUPPORTED_Autoneg | SUPPORTED_TP | SUPPORTED_MII |
SUPPORTED_10baseT_Half | SUPPORTED_10baseT_Full |
SUPPORTED_100baseT_Half | SUPPORTED_100baseT_Full;
- ecmd.port = PORT_TP;
- ecmd.transceiver = XCVR_EXTERNAL;
- ecmd.phy_address = mdio_phy_addr;
- ecmd.speed = current_speed;
- ecmd.duplex = full_duplex ? DUPLEX_FULL : DUPLEX_HALF;
- ecmd.advertising = ADVERTISED_TP;
- if (current_duplex == autoneg && current_speed_selection == 0)
- ecmd.advertising |= ADVERTISED_Autoneg;
- else {
- ecmd.advertising |=
- ADVERTISED_10baseT_Half | ADVERTISED_10baseT_Full |
- ADVERTISED_100baseT_Half | ADVERTISED_100baseT_Full;
- if (current_speed_selection == 10)
- ecmd.advertising &= ~(ADVERTISED_100baseT_Half | ADVERTISED_100baseT_Full);
- else if (current_speed_selection == 100)
- ecmd.advertising &= ~(ADVERTISED_10baseT_Half | ADVERTISED_10baseT_Full);
- if (current_duplex == half)
- ecmd.advertising &= ~(ADVERTISED_10baseT_Full | ADVERTISED_100baseT_Full);
- else if (current_duplex == full)
- ecmd.advertising &= ~(ADVERTISED_10baseT_Half | ADVERTISED_100baseT_Half);
- }
- ecmd.autoneg = AUTONEG_ENABLE;
- if (copy_to_user(ifr->ifr_data, &ecmd, sizeof (ecmd)))
- return -EFAULT;
- }
- break;
- case ETHTOOL_SSET:
- {
- if (!capable(CAP_NET_ADMIN)) {
- return -EPERM;
- }
- if (ecmd.autoneg == AUTONEG_ENABLE) {
- e100_set_duplex(dev, autoneg);
- e100_set_speed(dev, 0);
- } else {
- e100_set_duplex(dev, ecmd.duplex == DUPLEX_HALF ? half : full);
- e100_set_speed(dev, ecmd.speed == SPEED_10 ? 10: 100);
- }
- }
- break;
- case ETHTOOL_GDRVINFO:
- {
- struct ethtool_drvinfo info;
- memset((void *) &info, 0, sizeof (info));
- strncpy(info.driver, "ETRAX 100LX", sizeof(info.driver) - 1);
- strncpy(info.version, "$Revision: 1.31 $", sizeof(info.version) - 1);
- strncpy(info.fw_version, "N/A", sizeof(info.fw_version) - 1);
- strncpy(info.bus_info, "N/A", sizeof(info.bus_info) - 1);
- info.regdump_len = 0;
- info.eedump_len = 0;
- info.testinfo_len = 0;
- if (copy_to_user(ifr->ifr_data, &info, sizeof (info)))
- return -EFAULT;
- }
- break;
- case ETHTOOL_NWAY_RST:
- if (current_duplex == autoneg && current_speed_selection == 0)
- e100_negotiate(dev);
- break;
- default:
- return -EOPNOTSUPP;
- break;
+ ecmd->port = PORT_TP;
+ ecmd->transceiver = XCVR_EXTERNAL;
+ ecmd->phy_address = mdio_phy_addr;
+ ecmd->speed = current_speed;
+ ecmd->duplex = full_duplex ? DUPLEX_FULL : DUPLEX_HALF;
+ ecmd->advertising = ADVERTISED_TP;
+
+ if (current_duplex == autoneg && current_speed_selection == 0)
+ ecmd->advertising |= ADVERTISED_Autoneg;
+ else {
+ ecmd->advertising |=
+ ADVERTISED_10baseT_Half | ADVERTISED_10baseT_Full |
+ ADVERTISED_100baseT_Half | ADVERTISED_100baseT_Full;
+ if (current_speed_selection == 10)
+ ecmd->advertising &= ~(ADVERTISED_100baseT_Half |
+ ADVERTISED_100baseT_Full);
+ else if (current_speed_selection == 100)
+ ecmd->advertising &= ~(ADVERTISED_10baseT_Half |
+ ADVERTISED_10baseT_Full);
+ if (current_duplex == half)
+ ecmd->advertising &= ~(ADVERTISED_10baseT_Full |
+ ADVERTISED_100baseT_Full);
+ else if (current_duplex == full)
+ ecmd->advertising &= ~(ADVERTISED_10baseT_Half |
+ ADVERTISED_100baseT_Half);
}
+
+ ecmd->autoneg = AUTONEG_ENABLE;
return 0;
}
+static int e100_set_settings(struct net_device *dev,
+ struct ethtool_cmd *ecmd)
+{
+ if (ecmd->autoneg == AUTONEG_ENABLE) {
+ e100_set_duplex(dev, autoneg);
+ e100_set_speed(dev, 0);
+ } else {
+ e100_set_duplex(dev, ecmd->duplex == DUPLEX_HALF ? half : full);
+ e100_set_speed(dev, ecmd->speed == SPEED_10 ? 10: 100);
+ }
+
+ return 0;
+}
+
+static void e100_get_drvinfo(struct net_device *dev,
+ struct ethtool_drvinfo *info)
+{
+ strncpy(info->driver, "ETRAX 100LX", sizeof(info->driver) - 1);
+ strncpy(info->version, "$Revision: 1.31 $", sizeof(info->version) - 1);
+ strncpy(info->fw_version, "N/A", sizeof(info->fw_version) - 1);
+ strncpy(info->bus_info, "N/A", sizeof(info->bus_info) - 1);
+}
+
+static int e100_nway_reset(struct net_device *dev)
+{
+ if (current_duplex == autoneg && current_speed_selection == 0)
+ e100_negotiate(dev);
+ return 0;
+}
+
+static struct ethtool_ops e100_ethtool_ops = {
+ .get_settings = e100_get_settings,
+ .set_settings = e100_set_settings,
+ .get_drvinfo = e100_get_drvinfo,
+ .nway_reset = e100_nway_reset,
+ .get_link = ethtool_op_get_link,
+};
+
static int
e100_set_config(struct net_device *dev, struct ifmap *map)
{
