[SCSI] qla2xxx: Use dma_get_required_mask() in determining the 'ideal' DMA mask.
In order to efficiently utilise the ISP's IOCB
request-queue, use the dma_get_required_mask() function to
determine the use of command-type 2 or 3 IOCBs when queueing
SCSI commands. This applies to ISP2[123]xx chips only, as
the ISP24xx uses command-type 7 IOCBs which use 64bit DSDs.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/qla2xxx/qla_os.c b/drivers/scsi/qla2xxx/qla_os.c
index 9000659..995e521 100644
--- a/drivers/scsi/qla2xxx/qla_os.c
+++ b/drivers/scsi/qla2xxx/qla_os.c
@@ -1113,36 +1113,23 @@
static void
qla2x00_config_dma_addressing(scsi_qla_host_t *ha)
{
- /* Assume 32bit DMA address */
+ /* Assume a 32bit DMA mask. */
ha->flags.enable_64bit_addressing = 0;
- /*
- * Given the two variants pci_set_dma_mask(), allow the compiler to
- * assist in setting the proper dma mask.
- */
- if (sizeof(dma_addr_t) > 4) {
- if (pci_set_dma_mask(ha->pdev, DMA_64BIT_MASK) == 0) {
+ if (!dma_set_mask(&ha->pdev->dev, DMA_64BIT_MASK)) {
+ /* Any upper-dword bits set? */
+ if (MSD(dma_get_required_mask(&ha->pdev->dev)) &&
+ !pci_set_consistent_dma_mask(ha->pdev, DMA_64BIT_MASK)) {
+ /* Ok, a 64bit DMA mask is applicable. */
ha->flags.enable_64bit_addressing = 1;
ha->isp_ops.calc_req_entries = qla2x00_calc_iocbs_64;
ha->isp_ops.build_iocbs = qla2x00_build_scsi_iocbs_64;
-
- if (pci_set_consistent_dma_mask(ha->pdev,
- DMA_64BIT_MASK)) {
- qla_printk(KERN_DEBUG, ha,
- "Failed to set 64 bit PCI consistent mask; "
- "using 32 bit.\n");
- pci_set_consistent_dma_mask(ha->pdev,
- DMA_32BIT_MASK);
- }
- } else {
- qla_printk(KERN_DEBUG, ha,
- "Failed to set 64 bit PCI DMA mask, falling back "
- "to 32 bit MASK.\n");
- pci_set_dma_mask(ha->pdev, DMA_32BIT_MASK);
+ return;
}
- } else {
- pci_set_dma_mask(ha->pdev, DMA_32BIT_MASK);
}
+
+ dma_set_mask(&ha->pdev->dev, DMA_32BIT_MASK);
+ pci_set_consistent_dma_mask(ha->pdev, DMA_32BIT_MASK);
}
static int