[SCSI] advansys: Remove array of scsi targets
The driver was saving a scsi_device for each target, but wasn't doing
anything useful with them. Just delete the array.
Signed-off-by: Matthew Wilcox <willy@linux.intel.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/advansys.c b/drivers/scsi/advansys.c
index 4f047cc..737c0e4 100644
--- a/drivers/scsi/advansys.c
+++ b/drivers/scsi/advansys.c
@@ -2514,7 +2514,6 @@
} dvc_cfg;
ushort asc_n_io_port; /* Number I/O ports. */
ADV_SCSI_BIT_ID_TYPE init_tidmask; /* Target init./valid mask */
- struct scsi_device *device[ADV_MAX_TID + 1]; /* Mid-Level Scsi Device */
ushort reqcnt[ADV_MAX_TID + 1]; /* Starvation request count */
ADV_SCSI_BIT_ID_TYPE queue_full; /* Queue full mask */
ushort queue_full_cnt[ADV_MAX_TID + 1]; /* Queue full count */
@@ -10183,13 +10182,6 @@
asc_board_t *boardp = ASC_BOARDP(sdev->host);
boardp->flags |= ASC_SELECT_QUEUE_DEPTHS;
- /*
- * Save a pointer to the sdev and set its initial/maximum
- * queue depth. Only save the pointer for a lun0 dev though.
- */
- if (sdev->lun == 0)
- boardp->device[sdev->id] = sdev;
-
if (ASC_NARROW_BOARD(boardp))
advansys_narrow_slave_configure(sdev,
&boardp->dvc_var.asc_dvc_var);
@@ -11343,14 +11335,12 @@
ASC_DVC_VAR *asc_dvc_varp;
ADV_DVC_VAR *adv_dvc_varp;
ADV_SCSI_REQ_Q *adv_scsiqp;
- struct scsi_device *device;
int ret;
ASC_DBG2(1, "asc_execute_scsi_cmnd: scp 0x%lx, done 0x%lx\n",
(ulong)scp, (ulong)scp->scsi_done);
boardp = ASC_BOARDP(scp->device->host);
- device = boardp->device[scp->device->id];
if (ASC_NARROW_BOARD(boardp)) {
/*
