sky2: fix checksum bit management on some chips
The newer flavors of Yukon II use a different method for receive
checksum offload. This is indicated in the driver by the SKY2_HW_NEW_LE
flag. On these newer chips, the BMU_ENA_RX_CHKSUM should not be set.
The driver would get incorrectly toggle the bit, enabling the old
checksum logic on these chips and cause a BUG_ON() assertion. If
receive checksum was toggled via ethtool.
Reported-by: Kirill Smelkov <kirr@mns.spb.ru>
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/marvell/sky2.c b/drivers/net/ethernet/marvell/sky2.c
index cace36f..28a5445 100644
--- a/drivers/net/ethernet/marvell/sky2.c
+++ b/drivers/net/ethernet/marvell/sky2.c
@@ -4381,10 +4381,12 @@
struct sky2_port *sky2 = netdev_priv(dev);
netdev_features_t changed = dev->features ^ features;
- if (changed & NETIF_F_RXCSUM) {
- bool on = features & NETIF_F_RXCSUM;
- sky2_write32(sky2->hw, Q_ADDR(rxqaddr[sky2->port], Q_CSR),
- on ? BMU_ENA_RX_CHKSUM : BMU_DIS_RX_CHKSUM);
+ if ((changed & NETIF_F_RXCSUM) &&
+ !(sky2->hw->flags & SKY2_HW_NEW_LE)) {
+ sky2_write32(sky2->hw,
+ Q_ADDR(rxqaddr[sky2->port], Q_CSR),
+ (features & NETIF_F_RXCSUM)
+ ? BMU_ENA_RX_CHKSUM : BMU_DIS_RX_CHKSUM);
}
if (changed & NETIF_F_RXHASH)
