libata: improve ata_down_xfermask_limit()
Make ata_down_xfermask_limit() accept @sel instead of @force_pio0.
@sel selects how the xfermask limit will be adjusted. The following
selectors are defined.
* ATA_DNXFER_PIO : only speed down PIO
* ATA_DNXFER_DMA : only speed down DMA, don't cause transfer mode change
* ATA_DNXFER_40C : apply 40c cable limit
* ATA_DNXFER_FORCE_PIO : force PIO
* ATA_DNXFER_FORCE_PIO0 : force PIO0 (same as original with @force_pio0 == 1)
* ATA_DNXFER_ANY : same as original with @force_pio0 == 0
Currently, only ANY and FORCE_PIO0 are used to maintain the original
behavior. Other selectors will be used later to improve EH speed down
sequence.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/libata.h b/drivers/ata/libata.h
index 0ad7781..8533de6 100644
--- a/drivers/ata/libata.h
+++ b/drivers/ata/libata.h
@@ -41,6 +41,16 @@
enum {
/* flags for ata_dev_read_id() */
ATA_READID_POSTRESET = (1 << 0), /* reading ID after reset */
+
+ /* selector for ata_down_xfermask_limit() */
+ ATA_DNXFER_PIO = 0, /* speed down PIO */
+ ATA_DNXFER_DMA = 1, /* speed down DMA */
+ ATA_DNXFER_40C = 2, /* apply 40c cable limit */
+ ATA_DNXFER_FORCE_PIO = 3, /* force PIO */
+ ATA_DNXFER_FORCE_PIO0 = 4, /* force PIO0 */
+ ATA_DNXFER_ANY = 5, /* speed down any */
+
+ ATA_DNXFER_QUIET = (1 << 31),
};
extern struct workqueue_struct *ata_aux_wq;
@@ -69,7 +79,7 @@
extern int ata_dev_configure(struct ata_device *dev);
extern int sata_down_spd_limit(struct ata_port *ap);
extern int sata_set_spd_needed(struct ata_port *ap);
-extern int ata_down_xfermask_limit(struct ata_device *dev, int force_pio0);
+extern int ata_down_xfermask_limit(struct ata_device *dev, unsigned int sel);
extern int ata_set_mode(struct ata_port *ap, struct ata_device **r_failed_dev);
extern void ata_sg_clean(struct ata_queued_cmd *qc);
extern void ata_qc_free(struct ata_queued_cmd *qc);
