powerpc: Implement GPIO driver for simple memory-mapped banks
The driver supports very simple GPIO controllers, that is, when a
controller provides just a 'data' register. Such controllers may be
found in various BCSRs (Board's FPGAs used to control board's
switches, LEDs, chip-selects, Ethernet/USB PHY power, etc).
So far we support only 1-byte GPIO banks. Support for other widths may
be implemented when/if needed.
p.s.
To avoid "made up" compatible entries (like compatible = "simple-gpio"),
boards must call simple_gpiochip_init() to pass the compatible string.
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/sysdev/Makefile b/arch/powerpc/sysdev/Makefile
index 5afce11..b33b28a 100644
--- a/arch/powerpc/sysdev/Makefile
+++ b/arch/powerpc/sysdev/Makefile
@@ -17,6 +17,7 @@
obj-$(CONFIG_FSL_LBC) += fsl_lbc.o
obj-$(CONFIG_FSL_GTM) += fsl_gtm.o
obj-$(CONFIG_MPC8xxx_GPIO) += mpc8xxx_gpio.o
+obj-$(CONFIG_SIMPLE_GPIO) += simple_gpio.o
obj-$(CONFIG_RAPIDIO) += fsl_rio.o
obj-$(CONFIG_TSI108_BRIDGE) += tsi108_pci.o tsi108_dev.o
obj-$(CONFIG_QUICC_ENGINE) += qe_lib/
