USB: EHCI, OHCI: handover changes
This patch (as887) changes the way ehci-hcd and ohci-hcd handle a loss
of VBUS power during suspend. In order for the USB-persist facility
to work correctly, it is necessary for low- and full-speed devices
attached to a high-speed port to be handed back to the companion
controller during resume processing.
This entails three changes: adding code to ehci-hcd to perform the
handover, removing code from ohci-hcd to turn off ports during
root-hub reinit, and adding code to ohci-hcd to turn on ports during
PCI controller resume. (Other bus glue resume methods for platforms
supporting high-speed controllers would need a similar change, if any
existed.)
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/host/ohci-hcd.c b/drivers/usb/host/ohci-hcd.c
index a66637e..ce05e5f 100644
--- a/drivers/usb/host/ohci-hcd.c
+++ b/drivers/usb/host/ohci-hcd.c
@@ -510,15 +510,7 @@
// flush the writes
(void) ohci_readl (ohci, &ohci->regs->control);
msleep(temp);
- temp = roothub_a (ohci);
- if (!(temp & RH_A_NPS)) {
- /* power down each port */
- for (temp = 0; temp < ohci->num_ports; temp++)
- ohci_writel (ohci, RH_PS_LSDA,
- &ohci->regs->roothub.portstatus [temp]);
- }
- // flush those writes
- (void) ohci_readl (ohci, &ohci->regs->control);
+
memset (ohci->hcca, 0, sizeof (struct ohci_hcca));
/* 2msec timelimit here means no irqs/preempt */
@@ -826,17 +818,8 @@
if ((temp = ohci_run (ohci)) < 0) {
ohci_err (ohci, "can't restart, %d\n", temp);
return temp;
- } else {
- /* here we "know" root ports should always stay powered,
- * and that if we try to turn them back on the root hub
- * will respond to CSC processing.
- */
- i = ohci->num_ports;
- while (i--)
- ohci_writel (ohci, RH_PS_PSS,
- &ohci->regs->roothub.portstatus [i]);
- ohci_dbg (ohci, "restart complete\n");
}
+ ohci_dbg(ohci, "restart complete\n");
return 0;
}
#endif
