| Device tree bindings for GPMC connected NANDs |
| |
| GPMC connected NAND (found on OMAP boards) are represented as child nodes of |
| the GPMC controller with a name of "nand". |
| |
| All timing relevant properties as well as generic gpmc child properties are |
| explained in a separate documents - please refer to |
| Documentation/devicetree/bindings/bus/ti-gpmc.txt |
| |
| For NAND specific properties such as ECC modes or bus width, please refer to |
| Documentation/devicetree/bindings/mtd/nand.txt |
| |
| |
| Required properties: |
| |
| - reg: The CS line the peripheral is connected to |
| |
| Optional properties: |
| |
| - nand-bus-width: Set this numeric value to 16 if the hardware |
| is wired that way. If not specified, a bus |
| width of 8 is assumed. |
| |
| - ti,nand-ecc-opt: A string setting the ECC layout to use. One of: |
| |
| "sw" Software method (default) |
| "hw" Hardware method |
| "hw-romcode" gpmc hamming mode method & romcode layout |
| "bch4" 4-bit BCH ecc code |
| "bch8" 8-bit BCH ecc code |
| |
| - ti,nand-xfer-type: A string setting the data transfer type. One of: |
| |
| "prefetch-polled" Prefetch polled mode (default) |
| "polled" Polled mode, without prefetch |
| "prefetch-dma" Prefetch enabled sDMA mode |
| "prefetch-irq" Prefetch enabled irq mode |
| |
| - elm_id: Specifies elm device node. This is required to support BCH |
| error correction using ELM module. |
| |
| For inline partiton table parsing (optional): |
| |
| - #address-cells: should be set to 1 |
| - #size-cells: should be set to 1 |
| |
| Example for an AM33xx board: |
| |
| gpmc: gpmc@50000000 { |
| compatible = "ti,am3352-gpmc"; |
| ti,hwmods = "gpmc"; |
| reg = <0x50000000 0x1000000>; |
| interrupts = <100>; |
| gpmc,num-cs = <8>; |
| gpmc,num-waitpins = <2>; |
| #address-cells = <2>; |
| #size-cells = <1>; |
| ranges = <0 0 0x08000000 0x2000>; /* CS0: NAND */ |
| elm_id = <&elm>; |
| |
| nand@0,0 { |
| reg = <0 0 0>; /* CS0, offset 0 */ |
| nand-bus-width = <16>; |
| ti,nand-ecc-opt = "bch8"; |
| ti,nand-xfer-type = "polled"; |
| |
| gpmc,sync-clk-ps = <0>; |
| gpmc,cs-on-ns = <0>; |
| gpmc,cs-rd-off-ns = <44>; |
| gpmc,cs-wr-off-ns = <44>; |
| gpmc,adv-on-ns = <6>; |
| gpmc,adv-rd-off-ns = <34>; |
| gpmc,adv-wr-off-ns = <44>; |
| gpmc,we-off-ns = <40>; |
| gpmc,oe-off-ns = <54>; |
| gpmc,access-ns = <64>; |
| gpmc,rd-cycle-ns = <82>; |
| gpmc,wr-cycle-ns = <82>; |
| gpmc,wr-access-ns = <40>; |
| gpmc,wr-data-mux-bus-ns = <0>; |
| |
| #address-cells = <1>; |
| #size-cells = <1>; |
| |
| /* partitions go here */ |
| }; |
| }; |
| |