mac80211: Add HT rates into RX status reporting
This patch adds option for HT-enabled drivers to report HT rates
(HT20/HT40, short GI, MCS index) to mac80211. These rates are
currently not in the rate table, so the rate_idx is used to indicate
MCS index.
Signed-off-by: Jouni Malinen <jouni.malinen@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index 22ae72c..9428d3e 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -436,6 +436,9 @@
* is valid. This is useful in monitor mode and necessary for beacon frames
* to enable IBSS merging.
* @RX_FLAG_SHORTPRE: Short preamble was used for this frame
+ * @RX_FLAG_HT: HT MCS was used and rate_idx is MCS index
+ * @RX_FLAG_40MHZ: HT40 (40 MHz) was used
+ * @RX_FLAG_SHORT_GI: Short guard interval was used
*/
enum mac80211_rx_flags {
RX_FLAG_MMIC_ERROR = 1<<0,
@@ -446,7 +449,10 @@
RX_FLAG_FAILED_FCS_CRC = 1<<5,
RX_FLAG_FAILED_PLCP_CRC = 1<<6,
RX_FLAG_TSFT = 1<<7,
- RX_FLAG_SHORTPRE = 1<<8
+ RX_FLAG_SHORTPRE = 1<<8,
+ RX_FLAG_HT = 1<<9,
+ RX_FLAG_40MHZ = 1<<10,
+ RX_FLAG_SHORT_GI = 1<<11,
};
/**
@@ -466,7 +472,8 @@
* @noise: noise when receiving this frame, in dBm.
* @qual: overall signal quality indication, in percent (0-100).
* @antenna: antenna used
- * @rate_idx: index of data rate into band's supported rates
+ * @rate_idx: index of data rate into band's supported rates or MCS index if
+ * HT rates are use (RX_FLAG_HT)
* @flag: %RX_FLAG_*
*/
struct ieee80211_rx_status {
diff --git a/net/mac80211/mlme.c b/net/mac80211/mlme.c
index e4d1fca..a444b38 100644
--- a/net/mac80211/mlme.c
+++ b/net/mac80211/mlme.c
@@ -1613,8 +1613,13 @@
* e.g: at 1 MBit that means mactime is 192 usec earlier
* (=24 bytes * 8 usecs/byte) than the beacon timestamp.
*/
- int rate = local->hw.wiphy->bands[band]->
+ int rate;
+ if (rx_status->flag & RX_FLAG_HT) {
+ rate = 65; /* TODO: HT rates */
+ } else {
+ rate = local->hw.wiphy->bands[band]->
bitrates[rx_status->rate_idx].bitrate;
+ }
rx_timestamp = rx_status->mactime + (24 * 8 * 10 / rate);
} else if (local && local->ops && local->ops->get_tsf)
/* second best option: get current TSF */
diff --git a/net/mac80211/rx.c b/net/mac80211/rx.c
index 73cf126..b729c00 100644
--- a/net/mac80211/rx.c
+++ b/net/mac80211/rx.c
@@ -149,7 +149,17 @@
pos++;
/* IEEE80211_RADIOTAP_RATE */
- *pos = rate->bitrate / 5;
+ if (status->flag & RX_FLAG_HT) {
+ /*
+ * TODO: add following information into radiotap header once
+ * suitable fields are defined for it:
+ * - MCS index (status->rate_idx)
+ * - HT40 (status->flag & RX_FLAG_40MHZ)
+ * - short-GI (status->flag & RX_FLAG_SHORT_GI)
+ */
+ *pos = 0;
+ } else
+ *pos = rate->bitrate / 5;
pos++;
/* IEEE80211_RADIOTAP_CHANNEL */
@@ -1849,9 +1859,15 @@
if (!(sdata->dev->flags & IFF_PROMISC))
return 0;
rx->flags &= ~IEEE80211_RX_RA_MATCH;
- } else if (!rx->sta)
+ } else if (!rx->sta) {
+ int rate_idx;
+ if (rx->status->flag & RX_FLAG_HT)
+ rate_idx = 0; /* TODO: HT rates */
+ else
+ rate_idx = rx->status->rate_idx;
rx->sta = ieee80211_ibss_add_sta(sdata, bssid, hdr->addr2,
- BIT(rx->status->rate_idx));
+ BIT(rate_idx));
+ }
break;
case NL80211_IFTYPE_MESH_POINT:
if (!multicast &&
@@ -2057,7 +2073,13 @@
tid_agg_rx->reorder_buf[index]->cb,
sizeof(status));
sband = local->hw.wiphy->bands[status.band];
- rate = &sband->bitrates[status.rate_idx];
+ if (status.flag & RX_FLAG_HT) {
+ /* TODO: HT rates */
+ rate = sband->bitrates;
+ } else {
+ rate = &sband->bitrates
+ [status.rate_idx];
+ }
__ieee80211_rx_handle_packet(hw,
tid_agg_rx->reorder_buf[index],
&status, rate);
@@ -2101,7 +2123,10 @@
memcpy(&status, tid_agg_rx->reorder_buf[index]->cb,
sizeof(status));
sband = local->hw.wiphy->bands[status.band];
- rate = &sband->bitrates[status.rate_idx];
+ if (status.flag & RX_FLAG_HT)
+ rate = sband->bitrates; /* TODO: HT rates */
+ else
+ rate = &sband->bitrates[status.rate_idx];
__ieee80211_rx_handle_packet(hw, tid_agg_rx->reorder_buf[index],
&status, rate);
tid_agg_rx->stored_mpdu_num--;
@@ -2189,15 +2214,26 @@
}
sband = local->hw.wiphy->bands[status->band];
-
- if (!sband ||
- status->rate_idx < 0 ||
- status->rate_idx >= sband->n_bitrates) {
+ if (!sband) {
WARN_ON(1);
return;
}
- rate = &sband->bitrates[status->rate_idx];
+ if (status->flag & RX_FLAG_HT) {
+ /* rate_idx is MCS index */
+ if (WARN_ON(status->rate_idx < 0 ||
+ status->rate_idx >= 76))
+ return;
+ /* HT rates are not in the table - use the highest legacy rate
+ * for now since other parts of mac80211 may not yet be fully
+ * MCS aware. */
+ rate = &sband->bitrates[sband->n_bitrates - 1];
+ } else {
+ if (WARN_ON(status->rate_idx < 0 ||
+ status->rate_idx >= sband->n_bitrates))
+ return;
+ rate = &sband->bitrates[status->rate_idx];
+ }
/*
* key references and virtual interfaces are protected using RCU
