[TG3]: add 5780 basic jumbo frame support
Add basic jumbo frames support for 5780. This chip supports jumbo frames
on the standard receive ring without the jumbo ring. The
TG3_FLAG_JUMBO_ENABLE is changed to TG3_FLAG_JUMBO_RING_ENABLE to
indicate using the jumbo ring on 5704 and older chips. A new
TG3_FLG2_JUMBO_CAPABLE flag is added to indicate jumbo frames support
with or without the jumbo ring.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index b01f6a0..9188a9b 100644
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -90,7 +90,7 @@
/* hardware minimum and maximum for a single frame's data payload */
#define TG3_MIN_MTU 60
#define TG3_MAX_MTU(tp) \
- (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS) ? 9000 : 1500)
+ ((tp->tg3_flags2 & TG3_FLG2_JUMBO_CAPABLE) ? 9000 : 1500)
/* These numbers seem to be hard coded in the NIC firmware somehow.
* You can't change the ring sizes, but you can change where you place
@@ -914,7 +914,7 @@
if ((tp->phy_id & PHY_ID_MASK) == PHY_ID_BCM5401) {
/* Cannot do read-modify-write on 5401 */
tg3_writephy(tp, MII_TG3_AUX_CTRL, 0x4c20);
- } else if (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS)) {
+ } else if (tp->tg3_flags2 & TG3_FLG2_JUMBO_CAPABLE) {
u32 phy_reg;
/* Set bit 14 with read-modify-write to preserve other bits */
@@ -926,7 +926,7 @@
/* Set phy register 0x10 bit 0 to high fifo elasticity to support
* jumbo frames transmission.
*/
- if (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS)) {
+ if (tp->tg3_flags2 & TG3_FLG2_JUMBO_CAPABLE) {
u32 phy_reg;
if (!tg3_readphy(tp, MII_TG3_EXT_CTRL, &phy_reg))
@@ -3444,9 +3444,9 @@
dev->mtu = new_mtu;
if (new_mtu > ETH_DATA_LEN)
- tp->tg3_flags |= TG3_FLAG_JUMBO_ENABLE;
+ tp->tg3_flags |= TG3_FLAG_JUMBO_RING_ENABLE;
else
- tp->tg3_flags &= ~TG3_FLAG_JUMBO_ENABLE;
+ tp->tg3_flags &= ~TG3_FLAG_JUMBO_RING_ENABLE;
}
static int tg3_change_mtu(struct net_device *dev, int new_mtu)
@@ -3588,7 +3588,7 @@
(i << RXD_OPAQUE_INDEX_SHIFT));
}
- if (tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE) {
+ if (tp->tg3_flags & TG3_FLAG_JUMBO_RING_ENABLE) {
for (i = 0; i < TG3_RX_JUMBO_RING_SIZE; i++) {
struct tg3_rx_buffer_desc *rxd;
@@ -3609,7 +3609,7 @@
break;
}
- if (tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE) {
+ if (tp->tg3_flags & TG3_FLAG_JUMBO_RING_ENABLE) {
for (i = 0; i < tp->rx_jumbo_pending; i++) {
if (tg3_alloc_rx_skb(tp, RXD_OPAQUE_RING_JUMBO,
-1, i) < 0)
@@ -5277,7 +5277,7 @@
}
#endif
- if (!(tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE)) {
+ if (tp->dev->mtu <= ETH_DATA_LEN) {
tw32(BUFMGR_MB_RDMA_LOW_WATER,
tp->bufmgr_config.mbuf_read_dma_low_water);
tw32(BUFMGR_MB_MACRX_LOW_WATER,
@@ -5352,7 +5352,7 @@
/* Setup replenish threshold. */
tw32(RCVBDI_JUMBO_THRESH, tp->rx_jumbo_pending / 8);
- if (tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE) {
+ if (tp->tg3_flags & TG3_FLAG_JUMBO_RING_ENABLE) {
tw32(RCVDBDI_JUMBO_BD + TG3_BDINFO_HOST_ADDR + TG3_64BIT_REG_HIGH,
((u64) tp->rx_jumbo_mapping >> 32));
tw32(RCVDBDI_JUMBO_BD + TG3_BDINFO_HOST_ADDR + TG3_64BIT_REG_LOW,
@@ -5413,7 +5413,7 @@
tw32_rx_mbox(MAILBOX_RCV_STD_PROD_IDX + TG3_64BIT_REG_LOW,
tp->rx_std_ptr);
- tp->rx_jumbo_ptr = (tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE) ?
+ tp->rx_jumbo_ptr = (tp->tg3_flags & TG3_FLAG_JUMBO_RING_ENABLE) ?
tp->rx_jumbo_pending : 0;
tw32_rx_mbox(MAILBOX_RCV_JUMBO_PROD_IDX + TG3_64BIT_REG_LOW,
tp->rx_jumbo_ptr);
@@ -8991,6 +8991,11 @@
if (tp->tg3_flags2 & TG3_FLG2_5750_PLUS)
tp->tg3_flags2 |= TG3_FLG2_HW_TSO;
+ if (GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5705 &&
+ GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5750 &&
+ GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5752)
+ tp->tg3_flags2 |= TG3_FLG2_JUMBO_CAPABLE;
+
if (pci_find_capability(tp->pdev, PCI_CAP_ID_EXP) != 0)
tp->tg3_flags2 |= TG3_FLG2_PCI_EXPRESS;
@@ -9117,8 +9122,9 @@
/* Derive initial jumbo mode from MTU assigned in
* ether_setup() via the alloc_etherdev() call
*/
- if (tp->dev->mtu > ETH_DATA_LEN)
- tp->tg3_flags |= TG3_FLAG_JUMBO_ENABLE;
+ if (tp->dev->mtu > ETH_DATA_LEN &&
+ GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5780)
+ tp->tg3_flags |= TG3_FLAG_JUMBO_RING_ENABLE;
/* Determine WakeOnLan speed to use. */
if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5700 ||
diff --git a/drivers/net/tg3.h b/drivers/net/tg3.h
index 46fa105..7cb2eef 100644
--- a/drivers/net/tg3.h
+++ b/drivers/net/tg3.h
@@ -2125,7 +2125,7 @@
#define TG3_FLAG_NO_TX_PSEUDO_CSUM 0x00100000
#define TG3_FLAG_NO_RX_PSEUDO_CSUM 0x00200000
#define TG3_FLAG_SERDES_WOL_CAP 0x00400000
-#define TG3_FLAG_JUMBO_ENABLE 0x00800000
+#define TG3_FLAG_JUMBO_RING_ENABLE 0x00800000
#define TG3_FLAG_10_100_ONLY 0x01000000
#define TG3_FLAG_PAUSE_AUTONEG 0x02000000
#define TG3_FLAG_BROKEN_CHECKSUMS 0x10000000
@@ -2155,6 +2155,7 @@
#define TG3_FLG2_5750_PLUS 0x00080000
#define TG3_FLG2_PROTECTED_NVRAM 0x00100000
#define TG3_FLG2_USING_MSI 0x00200000
+#define TG3_FLG2_JUMBO_CAPABLE 0x00400000
u32 split_mode_max_reqs;
#define SPLIT_MODE_5704_MAX_REQ 3
